On 3/30/2017 3:12 AM, Sean Young wrote:
> On Wed, Mar 29, 2017 at 06:04:58PM -0400, A Sun wrote:
>> On 3/29/2017 5:06 PM, Sean Young wrote:
>> <snip>
>>>
>>> Anyway, you're right and this patch looks ok. It would be nice to have the
>>> tx case handled too though.
>>>
>>> Thanks
>>> Sean
>>>
>>
>> Thanks; I'm looking at handling the tx case. If I can figure out the details, I'll post a new patch proposal separate, and likely dependent, on this one.
>>
>> My main obstacle at the moment, is I'm looking for a way to get mceusb device to respond with a USB TX error halt/stall (rather than the typical ACK and NAK) on a TX endpoint, in order to test halt/stall error detection and recovery for TX. ..A Sun
>
> If you send IR, the drivers send a usb packet. However, the kernel will
> sleep for however long the IR is in ir_lirc_transmit_ir, so your other option
> is to set the transmit carrier repeatedly instead. You'd have to set the
> carrier to a different value every time.
>
>
> {
> int fd, carrier;
>
> fd = open("/dev/lirc0", O_RDWR);
> carrier = 38000;
> for (;;) {
> ioctl(fd, LIRC_SET_SEND_CARRIER, &carrier);
> if (++carrier >= 40000)
> carrier = 38000;
> }
> }
>
>
> Sean
>
Thanks, this is good to know, for testing where multiple TX I/Os are pending prior to fault.
I found a way to set up the TX -EPIPE fault administratively:
retval = usb_control_msg(ir->usbdev, usb_sndctrlpipe(ir->usbdev, 0),
USB_REQ_SET_FEATURE, USB_RECIP_ENDPOINT,
USB_ENDPOINT_HALT, usb_pipeendpoint(ir->pipe_out),
NULL, 0, USB_CTRL_SET_TIMEOUT);
dev_dbg(ir->dev, "set halt retval, %d", retval);
and have replications now for TX error and lock -out. Error occurs for every TX. No message flooding otherwise, as we expect. The RX side remains working.
...
[ 249.986174] mceusb 1-1.2:1.0: requesting 38000 HZ carrier
[ 249.986210] mceusb 1-1.2:1.0: send request called (size=0x4)
[ 249.986256] mceusb 1-1.2:1.0: send request complete (res=0)
[ 249.986403] mceusb 1-1.2:1.0: Error: request urb status = -32 (TX HALT)
[ 249.999885] mceusb 1-1.2:1.0: send request called (size=0x3)
[ 249.999929] mceusb 1-1.2:1.0: send request complete (res=0)
[ 250.000013] mceusb 1-1.2:1.0: Error: request urb status = -32 (TX HALT)
[ 250.019830] mceusb 1-1.2:1.0: send request called (size=0x21)
[ 250.019868] mceusb 1-1.2:1.0: send request complete (res=0)
[ 250.020007] mceusb 1-1.2:1.0: Error: request urb status = -32 (TX HALT)
...
