Re: [PATCH v5 15/39] [media] v4l2: add a frame interval error event

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri 2017-03-10 10:37:21, Steve Longerbeam wrote:
> Hi Hans,
> 
> On 03/10/2017 04:03 AM, Hans Verkuil wrote:
> >On 10/03/17 05:52, Steve Longerbeam wrote:
> >>Add a new FRAME_INTERVAL_ERROR event to signal that a video capture or
> >>output device has measured an interval between the reception or transmit
> >>completion of two consecutive frames of video that is outside the nominal
> >>frame interval by some tolerance value.
> >
> >Reading back what was said on this I agree with Sakari that this doesn't
> >belong here.
> >
> >Userspace can detect this just as easily (if not easier) with a timeout.
> >
> 
> 
> Unfortunately measuring frame intervals from userland is not accurate
> enough for i.MX6.
> 
> The issue here is that the IPUv3, specifically the CSI unit, can
> permanently lose vertical sync if there are truncated frames sent
> on the bt.656 bus. We have seen a single missing line of video cause
> loss of vertical sync. The only way to correct this is to shutdown
> the IPU capture hardware and restart, which can be accomplished
> simply by restarting streaming from userland.
> 
> There are no other indicators from the sensor about these short
> frame events (believe me, we've exhausted all avenues with the ADV718x).
> And the IPUv3 DMA engine has no status indicators for short frames
> either. So the only way to detect them is by measuring frame intervals.
> 
> The intervals have to be able to resolve a single line of missing video.
> With a PAL video source that requires better than 58 usec accuracy.
> 
> There is too much uncertainty to resolve this at user level. The
> driver is able to resolve this by measuring intervals between hardware
> interrupts as long as interrupt latency is reasonably low, and we
> have another method using the i.MX6 hardware input capture support
> that can measure these intervals very accurately with no errors
> introduced by interrupt latency.

Requiring < 58 usec interrupt latency for correct operation is a
little too optimistic, no?
									Pavel
-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html

Attachment: signature.asc
Description: Digital signature


[Index of Archives]     [Linux Input]     [Video for Linux]     [Gstreamer Embedded]     [Mplayer Users]     [Linux USB Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux