From: Hans Verkuil <hans.verkuil@xxxxxxxxx>
This patch replaces the ov7670 with the ov2640. This patch is not
meant to be merged but is for demonstration purposes only.
Signed-off-by: Hans Verkuil <hans.verkuil@xxxxxxxxx>
---
arch/arm/boot/dts/at91-sama5d3_xplained.dts | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
index b10f8b9e6375..65ccb35213a9 100644
--- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
@@ -71,7 +71,7 @@
#address-cells = <1>;
#size-cells = <0>;
isi_0: endpoint {
- remote-endpoint = <&ov7670_0>;
+ remote-endpoint = <&ov2640_0>;
bus-width = <8>;
vsync-active = <1>;
hsync-active = <1>;
@@ -87,20 +87,20 @@
i2c1: i2c@f0018000 {
status = "okay";
- ov7670: camera@21 {
- compatible = "ovti,ov7670";
- reg = <0x21>;
+ ov2640: camera@30 {
+ compatible = "ovti,ov2640";
+ reg = <0x30>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_pck0_as_isi_mck &pinctrl_sensor_power &pinctrl_sensor_reset>;
- reset-gpios = <&pioE 11 GPIO_ACTIVE_LOW>;
- powerdown-gpios = <&pioE 13 GPIO_ACTIVE_HIGH>;
+ resetb-gpios = <&pioE 11 GPIO_ACTIVE_LOW>;
+ pwdn-gpios = <&pioE 13 GPIO_ACTIVE_HIGH>;
clocks = <&pck0>;
- clock-names = "xclk";
+ clock-names = "xvclk";
assigned-clocks = <&pck0>;
assigned-clock-rates = <25000000>;
port {
- ov7670_0: endpoint {
+ ov2640_0: endpoint {
remote-endpoint = <&isi_0>;
bus-width = <8>;
};
--
2.11.0
