Hi Rob, On Wed, Feb 01, 2017 at 10:50:59AM -0600, Rob Herring wrote: > > + remote-endpoint = <&ov2640_0>; > > + bus-width = <8>; > > + vsync-active = <1>; > > + hsync-active = <1>; > > Which side of the connect is supposed to define these? Today we have endpoint properties at each endpoint independently of the remote endpoint. I guess you could obtain the endpoint properties from the remote endpoint as well. There are exceptions though. The configuration might not always be exactly the same. The parallel interface is a little bit special: you could conceivably have a transmitter with 8 wires but a receiver that could only use 10 or more. The wiring could be such that the two most significant bits of the transmitter would be wired to the two least significant bits on the receiver side. In this case the bus-width property would have different values at each endpoint. If we were to do something like that, it should be done everywhere and such exceptions be handled somehow. The CSI-2 lane mapping configuration (where supported by the hardware) is also specific to an endpoint. -- Kind regards, Sakari Ailus e-mail: sakari.ailus@xxxxxx XMPP: sailus@xxxxxxxxxxxxxx -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
