Hi Lars,
On 2016-11-29 12:23:48 +0100, Lars-Peter Clausen wrote:
> The adv7604 driver platform data contains fields for configuring the drive
> strength of the output pins. When probing the driver through DT these
> fields are not explicitly initialized, which means they are left at 0. This
> is a reserved setting for the drive strength configuration though and can
> cause signal integrity issues.
>
> Whether these signal integrity issues are visible depends on the PCB
> specifics (e.g. the higher the load capacitance for the output the more
> visible the issue). But it has been observed on existing solutions at high
> pixel clock rates.
>
> Initialize the drive strength settings to the power-on-reset value of the
> device when probing through devicetree to avoid this issue.
>
> Fixes: 0e158be0162b ("adv7604: Add DT support")
> Signed-off-by: Lars-Peter Clausen <lars@xxxxxxxxxx>
Tested on Renesas Koelsch board which uses a adv7612 for HDMI input.
Tested-by: Niklas Söderlund <niklas.soderlund+renesas@xxxxxxxxxxxx>
> ---
> drivers/media/i2c/adv7604.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/media/i2c/adv7604.c b/drivers/media/i2c/adv7604.c
> index 5630eb2..a4dc64a 100644
> --- a/drivers/media/i2c/adv7604.c
> +++ b/drivers/media/i2c/adv7604.c
> @@ -3132,6 +3132,9 @@ static int adv76xx_parse_dt(struct adv76xx_state *state)
> state->pdata.blank_data = 1;
> state->pdata.op_format_mode_sel = ADV7604_OP_FORMAT_MODE0;
> state->pdata.bus_order = ADV7604_BUS_ORDER_RGB;
> + state->pdata.dr_str_data = ADV76XX_DR_STR_MEDIUM_HIGH;
> + state->pdata.dr_str_clk = ADV76XX_DR_STR_MEDIUM_HIGH;
> + state->pdata.dr_str_sync = ADV76XX_DR_STR_MEDIUM_HIGH;
>
> return 0;
> }
> --
> 2.1.4
>
--
Regards,
Niklas Söderlund
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
