Hi Jack,
Am Montag, den 17.10.2016, 12:32 +0100 schrieb Jack Mitchell:
> Hi Philipp,
>
> I'm looking at how I would enable a parallel greyscale camera using this
> set of drivers and am a little bit confused. Do you have an example
> somewhere of a devicetree with an input node.
In your board device tree it should look somewhat like this:
&i2c1 {
sensor@48 {
compatible = "aptina,mt9v032m";
/* ... */
port {
cam_out: endpoint {
remote-endpoint = <&csi_in>;
}
};
};
};
/*
* This is the input port node corresponding to the 'CSI0' pad group,
* not necessarily the CSI0 port of IPU1 or IPU2. On i.MX6Q it's port@1
* of the mipi_ipu1_mux, on i.MX6DL it's port@4 of the ipu_csi0_mux,
* the csi0 label is added in patch 13/21.
*/
&csi0 {
#address-cells = <1>;
#size-cells = <0>;
csi_in: endpoint@0 {
bus-width = <8>;
data-shift = <12>;
hsync-active = <1>;
vsync-active = <1>;
pclk-sample = <1>;
remote-endpoint = <&cam_out>;
};
};
> I also have a further note below:
[...]
> > + if (raw && priv->smfc) {
>
> How does this ever get used? If I were to set 1X8 greyscale it wouldn't
> ever take this path, correct?
Thank you, that is a leftover from stripping down the driver to the
basics. I'll test with a grayscale camera and fix this in the next
version.
regards
Philipp
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
