On Tue, Jul 12, 2016 at 09:41:57AM -0300, Mauro Carvalho Chehab wrote:
> While reviewing the documentation gaps on LIRC, it was
> noticed that several ioctls aren't used by any LIRC drivers
> (nor at staging or mainstream).
>
> It doesn't make sense to document them, as they're not used
> anywhere. So, let's remove those from the lirc header.
Good to see these go.
>
> Signed-off-by: Mauro Carvalho Chehab <mchehab@xxxxxxxxxxxxxxxx>
> ---
> include/uapi/linux/lirc.h | 39 ++-------------------------------------
> 1 file changed, 2 insertions(+), 37 deletions(-)
>
> diff --git a/include/uapi/linux/lirc.h b/include/uapi/linux/lirc.h
> index 4b3ab2966b5a..991ab4570b8e 100644
> --- a/include/uapi/linux/lirc.h
> +++ b/include/uapi/linux/lirc.h
> @@ -90,20 +90,11 @@
>
> #define LIRC_GET_SEND_MODE _IOR('i', 0x00000001, __u32)
> #define LIRC_GET_REC_MODE _IOR('i', 0x00000002, __u32)
> -#define LIRC_GET_SEND_CARRIER _IOR('i', 0x00000003, __u32)
> -#define LIRC_GET_REC_CARRIER _IOR('i', 0x00000004, __u32)
> -#define LIRC_GET_SEND_DUTY_CYCLE _IOR('i', 0x00000005, __u32)
> -#define LIRC_GET_REC_DUTY_CYCLE _IOR('i', 0x00000006, __u32)
> #define LIRC_GET_REC_RESOLUTION _IOR('i', 0x00000007, __u32)
>
> #define LIRC_GET_MIN_TIMEOUT _IOR('i', 0x00000008, __u32)
> #define LIRC_GET_MAX_TIMEOUT _IOR('i', 0x00000009, __u32)
>
> -#define LIRC_GET_MIN_FILTER_PULSE _IOR('i', 0x0000000a, __u32)
> -#define LIRC_GET_MAX_FILTER_PULSE _IOR('i', 0x0000000b, __u32)
> -#define LIRC_GET_MIN_FILTER_SPACE _IOR('i', 0x0000000c, __u32)
> -#define LIRC_GET_MAX_FILTER_SPACE _IOR('i', 0x0000000d, __u32)
> -
> /* code length in bits, currently only for LIRC_MODE_LIRCCODE */
> #define LIRC_GET_LENGTH _IOR('i', 0x0000000f, __u32)
>
> @@ -113,7 +104,6 @@
> #define LIRC_SET_SEND_CARRIER _IOW('i', 0x00000013, __u32)
> #define LIRC_SET_REC_CARRIER _IOW('i', 0x00000014, __u32)
> #define LIRC_SET_SEND_DUTY_CYCLE _IOW('i', 0x00000015, __u32)
> -#define LIRC_SET_REC_DUTY_CYCLE _IOW('i', 0x00000016, __u32)
Also remove LIRC_CAN_SET_REC_DUTY_CYCLE and
LIRC_CAN_SET_REC_DUTY_CYCLE_RANGE.
> #define LIRC_SET_TRANSMITTER_MASK _IOW('i', 0x00000017, __u32)
>
> /*
> @@ -127,42 +117,17 @@
> #define LIRC_SET_REC_TIMEOUT_REPORTS _IOW('i', 0x00000019, __u32)
>
> /*
> - * pulses shorter than this are filtered out by hardware (software
> - * emulation in lirc_dev?)
> - */
> -#define LIRC_SET_REC_FILTER_PULSE _IOW('i', 0x0000001a, __u32)
> -/*
> - * spaces shorter than this are filtered out by hardware (software
> - * emulation in lirc_dev?)
> - */
> -#define LIRC_SET_REC_FILTER_SPACE _IOW('i', 0x0000001b, __u32)
> -/*
> - * if filter cannot be set independently for pulse/space, this should
> - * be used
> - */
> -#define LIRC_SET_REC_FILTER _IOW('i', 0x0000001c, __u32)
Also remove LIRC_CAN_SET_REC_FILTER.
> -
> -/*
> * if enabled from the next key press on the driver will send
> * LIRC_MODE2_FREQUENCY packets
> */
> #define LIRC_SET_MEASURE_CARRIER_MODE _IOW('i', 0x0000001d, __u32)
>
> /*
> - * to set a range use
> - * LIRC_SET_REC_DUTY_CYCLE_RANGE/LIRC_SET_REC_CARRIER_RANGE with the
> - * lower bound first and later
> - * LIRC_SET_REC_DUTY_CYCLE/LIRC_SET_REC_CARRIER with the upper bound
> + * to set a range use LIRC_SET_REC_CARRIER_RANGE with the
> + * lower bound first and later LIRC_SET_REC_CARRIER with the upper bound
> */
> -
> -#define LIRC_SET_REC_DUTY_CYCLE_RANGE _IOW('i', 0x0000001e, __u32)
> #define LIRC_SET_REC_CARRIER_RANGE _IOW('i', 0x0000001f, __u32)
>
> -#define LIRC_NOTIFY_DECODE _IO('i', 0x00000020)
Also remove LIRC_CAN_NOTIFY_DECODE.
> -
> -#define LIRC_SETUP_START _IO('i', 0x00000021)
> -#define LIRC_SETUP_END _IO('i', 0x00000022)
> -
> #define LIRC_SET_WIDEBAND_RECEIVER _IOW('i', 0x00000023, __u32)
>
> #endif
Sean
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
