According to the datasheet of Meson8b (S805) and GXBB (S905) the decoding mode is configured in AO_MF_IR_DEC_REG2 (offset 0x20) using bits 0-3. The "duration" field may not be set correctly when any of the hardware decoding modes. This can happen while a "default" decoding mode (either set by the bootloader or the chip's default, which uses NEC as it's default) is used. While here, I also added defines for the protocols which can be decoded by the hardware (more work is needed to be actually able to use them though). Signed-off-by: Martin Blumenstingl <martin.blumenstingl@xxxxxxxxxxxxxx> --- changes in v1 -> v2: - fixed subject of the patch to include meson-ir - fixed double-shifting of the decoder mode values drivers/media/rc/meson-ir.c | 24 ++++++++++++++++++------ 1 file changed, 18 insertions(+), 6 deletions(-) diff --git a/drivers/media/rc/meson-ir.c b/drivers/media/rc/meson-ir.c index fcc3b82..622a4160 100644 --- a/drivers/media/rc/meson-ir.c +++ b/drivers/media/rc/meson-ir.c @@ -32,13 +32,10 @@ #define IR_DEC_FRAME 0x14 #define IR_DEC_STATUS 0x18 #define IR_DEC_REG1 0x1c +#define IR_DEC_REG2 0x20 #define REG0_RATE_MASK (BIT(11) - 1) -#define REG1_MODE_MASK (BIT(7) | BIT(8)) -#define REG1_MODE_NEC (0 << 7) -#define REG1_MODE_GENERAL (2 << 7) - #define REG1_TIME_IV_SHIFT 16 #define REG1_TIME_IV_MASK ((BIT(13) - 1) << REG1_TIME_IV_SHIFT) @@ -51,6 +48,20 @@ #define REG1_RESET BIT(0) #define REG1_ENABLE BIT(15) +#define REG2_DEC_MODE_SHIFT 0 +#define REG2_DEC_MODE_MASK GENMASK(3, REG2_DEC_MODE_SHIFT) +#define REG2_DEC_MODE_NEC 0x0 +#define REG2_DEC_MODE_RAW 0x2 +#define REG2_DEC_MODE_THOMSON 0x4 +#define REG2_DEC_MODE_TOSHIBA 0x5 +#define REG2_DEC_MODE_SONY 0x6 +#define REG2_DEC_MODE_RC5 0x7 +#define REG2_DEC_MODE_RC6 0x9 +#define REG2_DEC_MODE_RCMM 0xa +#define REG2_DEC_MODE_DUOKAN 0xb +#define REG2_DEC_MODE_COMCAST 0xe +#define REG2_DEC_MODE_SANYO 0xf + #define STATUS_IR_DEC_IN BIT(8) #define MESON_TRATE 10 /* us */ @@ -158,8 +169,9 @@ static int meson_ir_probe(struct platform_device *pdev) /* Reset the decoder */ meson_ir_set_mask(ir, IR_DEC_REG1, REG1_RESET, REG1_RESET); meson_ir_set_mask(ir, IR_DEC_REG1, REG1_RESET, 0); - /* Set general operation mode */ - meson_ir_set_mask(ir, IR_DEC_REG1, REG1_MODE_MASK, REG1_MODE_GENERAL); + /* Enable raw/soft-decode mode */ + meson_ir_set_mask(ir, IR_DEC_REG2, REG2_DEC_MODE_MASK, + REG2_DEC_MODE_RAW << REG2_DEC_MODE_SHIFT); /* Set rate */ meson_ir_set_mask(ir, IR_DEC_REG0, REG0_RATE_MASK, MESON_TRATE - 1); /* IRQ on rising and falling edges */ -- 2.9.0 -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
