Hi, thank you! hermann pitton <hermann-pitton <at> arcor.de> writes: > > tuner 1-004b: chip found @ 0x96 (saa7133[0]) > > tda829x 1-004b: setting tuner address to 61 > > tda829x 1-004b: type set to tda8290+75a > > Nothing about the IR, but at least all tuner modules seem to be > correctly loaded. Im not using the IR because for now I dont need it, but I will try it. > What was your last good working kernel and was your eeprom already > failing there too, or is that new? I don't remember the last working kernel. I tried to recompile 2.6.25 but I obtain this error: DVB: Unable to find symbol tda10046_attach() saa7133[0]/dvb: frontend initialization failed The eeprom was working a few months ago giving this messages: saa7133[0]: found at 0000:01:02.0, rev: 209, irq: 19, latency: 64, mmio: 0xcfddf 800 saa7133[0]: subsystem: ffff:ffff, board: UNKNOWN/GENERIC [card=0,autodetected] saa7133[0]: board init: gpio is 600e000 saa7133[0]: i2c eeprom 00: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: registered device video0 [v4l2] saa7133[0]: registered device vbi0 Even then the card was not recognised. > Usually such is caused by bad contacts of the PCI slot or by a bad PSU, > but we have reports from a Pinnacle 50i with the same i2c remote. > > It has i2c troubles (ARB_LOST) and then also problems on loading the > tuner modules correctly. With disable_ir=1 for saa7134 it became at > least somewhat usable again. > > But for the 310i is another problem reported starting with kernel > 2.6.26. > > The 310i and the HVR1110 are the only cards with LowNoiseAmplifier > config = 1. Before 2.6.26 two buffers were sent to the tuner at 0x61, > doing some undocumented LNA configuration, since 2.6.26 they go to the > analog IF demodulator tda8290 at 0x4b. > > This was bisected here on the list and is wrong for the 300i. > Thread is "2.6.26 regression ..." > > The HVR1110 using the same new configuration seems to come in variants > with and without LNA and nobody knows, how to make a difference for > those cards. At least still no reports about troubles with the new LNA > configuration there. > > The attached patch against recent mercurial master v4l-dvb at > linuxtv.org tries to restore the pre 2.6.26 behaviour for DVB-T on the > 300i. > > It changes also the i2c remote address of the Upmost Purple TV from 0x7a > to 0x3d, since recent i2c on >= 2.6.30 complains about it as invalid > 7-bit address, just in case. > > Good luck, > > Hermann > > > Attachment (saa7134-try_to_improve_the_310i.patch): text/x-patch, 1925 bytes I tried the patch with 2.6.30.2 on v4l-dvb-1cb6f19d2c9d, but I get only some errors (I have rebooted): videodev: exports duplicate symbol video_unregister_device (owned by kernel) v4l2_common: exports duplicate symbol v4l2_chip_ident_i2c_client (owned by kerne l) saa7134: Unknown symbol v4l_bound_align_image I get these errors even not applying the patch. -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
