> Hi, > On Do, Jun 18, 2009 at 01:09:56 +0200, Hans Verkuil wrote: >> >> > Hi, >> > sorry for the nusable output! >> > I found the time consuming funktion: >> > bttv_init_card2(btv); >> > This takes about 4 min. today. >> > my new testcode: >> > /* needs to be done before i2c is registered */ >> > printk("linke 2:bttv_init_card1(btv);\n"); >> > >> > bttv_init_card1(btv); >> > >> > /* register i2c + gpio */ >> > printk("line 3: init_bttv_i2c(btv);\n"); >> > >> > init_bttv_i2c(btv); >> > >> > /* some card-specific stuff (needs working i2c) */ >> > printk("line4: some card-specific stuff needs working i2c >> \n"); >> > bttv_init_card2(btv); >> > printk("irq init\n"); >> > >> > init_irqreg(btv); >> > >> > dmesg output: >> > [ 2282.430209] bttv: driver version 0.9.18 loaded >> > [ 2282.430216] bttv: using 8 buffers with 2080k (520 pages) each for >> > capture >> > [ 2282.430313] bttv: Bt8xx card found (0). >> > [ 2282.430334] bttv0: Bt878 (rev 17) at 0000:00:0b.0, irq: 19, >> latency: >> > 32, mmio >> > : 0xf7800000 >> > [ 2282.430777] bttv0: using: Leadtek WinFast 2000/ WinFast 2000 XP >> > [card=34,insm >> > od option] >> > [ 2282.430839] bttv_gpio_tracking(bt >> > [ 2282.430843] bttv0: gpio: en=00000000, out=00000000 in=003ff502 >> [init] >> > [ 2282.430845] linke 2:bttv_init_card1(btv); >> > [ 2282.430859] line 3: init_bttv_i2c(btv); >> > [ 2282.430917] line4: some card-specific stuff needs working >> i2c >> > [ 2282.430922] bttv0: tuner type=24 >> > >> > Ok here is the 4 min dely and after that the following linkes were >> printed >> > out: >> > >> > [ 2416.836017] bttv0: audio absent, no audio device found! >> >> When you tested this with bttv 0.9.17, wasn't the delay then before the >> text 'tuner type=24'? >> >> Anyway, if you modprobe with the option 'audiodev=-1', will that solve >> this? If not, then can you do the same printk trick in the >> bttv_init_card2 >> function? > > I couldn't find a parameter audiodev in bttv module > Do you mean audioall?? > It has no effect. > So I need an older revision of v4l-dvb to test the 17. drivers. If you installed from the v4l-dvb repository, then 'modinfo bttv' should show the audiodev module option. It does for me. I'm not sure how you can get a bttv version of 0.9.18 without seeing that module option. I'm assuming your v4l-dvb tree is up to date? Regards, Hans -- Hans Verkuil - video4linux developer - sponsored by TANDBERG -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html