I have rev E1D9. Below is my dmesg output after applying the same change as Michel had shown. [ 466.833952] cx23885 driver version 0.0.1 loaded [ 466.833979] cx23885 0000:03:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 [ 466.833981] cx23885[0]/0: cx23885_dev_setup() Memory configured for PCIe bridge type 885 [ 466.833982] cx23885[0]/0: cx23885_init_tsport(portno=2) [ 466.834054] CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 [card=3,autodetected] [ 466.834055] cx23885[0]/0: cx23885_pci_quirks() [ 466.834057] cx23885[0]/0: cx23885_dev_setup() tuner_type = 0x0 tuner_addr = 0x0 [ 466.834059] cx23885[0]/0: cx23885_dev_setup() radio_type = 0x0 radio_addr = 0x0 [ 466.834059] cx23885[0]/0: cx23885_reset() [ 466.934080] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [VID A] [ 466.934091] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch2] [ 466.934092] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS1 B] [ 466.934106] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch4] [ 466.934107] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch5] [ 466.934108] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS2 C] [ 466.934122] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch7] [ 466.934123] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch8] [ 466.934125] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch9] [ 466.961642] tveeprom 1-0050: Hauppauge model 79001, rev E1D9, serial# 3450857 [ 466.961645] tveeprom 1-0050: MAC address is 00-0D-FE-34-A7-E9 [ 466.961646] tveeprom 1-0050: tuner model is Microtune MT2131 (idx 139, type 4) [ 466.961648] tveeprom 1-0050: TV standards NTSC(M) ATSC/DVB Digital (eeprom 0x88) [ 466.961649] tveeprom 1-0050: audio processor is CX23885 (idx 39) [ 466.961650] tveeprom 1-0050: decoder processor is CX23885 (idx 33) [ 466.961651] tveeprom 1-0050: has no radio, has IR receiver, has no IR transmitter [ 466.961652] cx23885[0]: hauppauge eeprom: model=79001 [ 466.961654] cx23885_dvb_register() allocating 1 frontend(s) [ 466.962728] cx23885[0]: cx23885 based dvb card [ 466.991727] MT2131: successfully identified at address 0x61 [ 466.991730] DVB: registering new adapter (cx23885[0]) [ 466.991732] DVB: registering adapter 0 frontend -1601531515 (Samsung S5H1409 QAM/8VSB Frontend)... [ 466.992748] cx23885_dev_checkrevision() Hardware revision = 0xc0 [ 466.992754] cx23885[0]/0: found at 0000:03:00.0, rev: 3, irq: 19, latency: 0, mmio: 0xea000000 [ 466.992761] cx23885 0000:03:00.0: setting latency timer to 64 On Thursday April 02 2009 10:43:36 am Steven Toth wrote: > Michel Dansereau wrote: > > Steve, > > Point taken about dropping the mailing list. > > Thanks! > > Michel > > Thanks, one last question. > > Look a the white Hauppauge label on the HVR-1250 tuner, its should say > something like Rev NNNN. > > What is your rev? > > - Steve > > -- > To unsubscribe from this list: send the line "unsubscribe linux-media" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
