I am getting the same with the Haupauge HVR-4000 after a recent Kernel Upgrade in Ubuntu Hardy (8.04). Any help greatly appreciated. Alec Christie 2009/1/15 Aaron Theodore <aaron@xxxxxxxxx> > > Hi I'm running Debian with kernel: 2.6.24-etchnhalf.1-686 > I recently baught a TeVii S420 DVB-S card and have been tring to get it to work. > > Firstly i built the v4l from: http://linuxtv.org/hg/v4l-dvb (hg clone) as the card was not detected. > On first reboot after new modules are installed i get a kernel soft lockup.... > > ------------------------------------------------- > Linux video capture interface: v2.00 > cx88/0: cx2388x v4l2 driver version 0.0.6 loaded > ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18 > ACPI: PCI Interrupt 0000:05:08.0[A] -> Link [APC3] -> GSI 18 (level, low) -> IRQ 21 > cx88[0]: subsystem: d420:9022, board: TeVii S420 DVB-S [card=73,autodetected], frontend(s): 1 > cx88[0]: TV tuner type -1, Radio tuner type -1 > cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded > tuner' 2-0068: chip found @ 0xd0 (cx88[0]) > cx88[0]/0: found at 0000:05:08.0, rev: 5, irq: 21, latency: 32, mmio: 0xd8000000 > cx88[0]/0: registered device video0 [v4l2] > cx88[0]/0: registered device vbi0 > tuner' 2-0068: tuner type not set > cx88[0]/2: cx2388x 8802 Driver Manager > ACPI: PCI Interrupt 0000:05:08.2[A] -> Link [APC3] -> GSI 18 (level, low) -> IRQ 21 > cx88[0]/2: found at 0000:05:08.2, rev: 5, irq: 21, latency: 32, mmio: 0xd9000000 > ACPI: PCI Interrupt Link [APCJ] enabled at IRQ 22 > ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [APCJ] -> GSI 22 (level, low) -> IRQ 17 > cx88/2: cx2388x dvb driver version 0.0.6 loaded > cx88/2: registering cx8802 driver, type: dvb access: shared > cx88[0]/2: subsystem: d420:9022, board: TeVii S420 DVB-S [card=73] > cx88[0]/2: cx2388x based DVB/ATSC card > BUG: soft lockup - CPU#0 stuck for 11s! [modprobe:1767] > > Pid: 1767, comm: modprobe Not tainted (2.6.24-etchnhalf.1-686 #1) > EIP: 0060:[<c02be0a5>] EFLAGS: 00000286 CPU: 0 > EIP is at _spin_lock+0x7/0xf > EAX: [removed] > ESI: [removed] > DS: [removed] > CR0: [removed] > DR0: [removed] > DR6: [removed] > [<c02bd4ba>] __mutex_lock_slowpath+0x17/0x7f > [<c01099da>] sched_clock+0x8/0x18 > [<c02bd39a>] mutex_lock+0xa/0xb > [<f89d60f7>] videobuf_dvb_get_frontend+0x11/0x37 [videobuf_dvb] > [<f8a4e3b2>] cx8802_dvb_probe+0xef/0x1a15 [cx88_dvb] > [<c0121da0>] check_preempt_wakeup+0x1e/0x7a > [<f89de540>] cx8802_register_driver+0x128/0x1e3 [ex8802] > [<c01437ab>] sys_int_module+0x15e3/0x16fb > [<c0164172>] vma_prio_tree_insert+0x17/0x2a > [<c012c887>] msleep+0x0/0x12 > [<c0103e66>] sysenter_past_esp+0x6b/0xa1 > ============================== > > Only way i can boot my system is to remove the PCI card. > > So then i tried using the drivers from TeVii ( http://www.tevii.com/Tevii_linuxdriver_0815.rar ) > These actually work but are based on what seems to be a v4l-dvb checkout from 2008-08-14. > > I can't use these old drivers because they conflict with other v4l-dvb modules i want to load for other tuner cards. > > Is there someway i can get the TeVii S420 working on the latest v4l-dvb modules? > > Also using the old drivers, just the following happens on boot > > ----------- > cx88[0]/2: subsystem: d420:9022, board: TeVii S420 DVB-S [card=73] > cx88[0]/2: cx2388x based DVB/ATSC card > intel8x0_measure_ac97_clock: measured 54726 usecs > intel8x0: clocking to 46908 > stv0288 id 11 > DVB: registering new adapter (cx88[0]) > DVB: registering frontend 0 (ST STV0288 DVB-S)... > ----------- > Could this perhaps be an issue with the intel8x0 module? > > > > ------------------------------------------------- > -- > To unsubscribe from this list: send the line "unsubscribe linux-media" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html -- Regards, Alec Christie -- To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
