Minor description changes for host attributes. Just some small changes to the host attribute descriptions. Remove the "version" sysfs entry. This entry was changed to two sysfs entries: driver_version and firmware_version. Reviewed-by: Scott Benesh <scott.benesh@xxxxxxxxxxxxx> Reviewed-by: Scott Teel <scott.teel@xxxxxxxxxxxxx> Reviewed-by: Mike McGowen <mike.mcgowen@xxxxxxxxxxxxx> Reviewed-by: Kevin Barnett <kevin.barnett@xxxxxxxxxxxxx> Signed-off-by: Don Brace <don.brace@xxxxxxxxxxxxx> --- man4/smartpqi.4 | 21 ++------------------- 1 file changed, 2 insertions(+), 19 deletions(-) diff --git a/man4/smartpqi.4 b/man4/smartpqi.4 index 34864e60755b..c51405c8b9cc 100644 --- a/man4/smartpqi.4 +++ b/man4/smartpqi.4 @@ -135,29 +135,12 @@ The host attribute is a write-only attribute. Writing to this attribute will cause the driver to scan for new, changed, or removed devices (e.g., hot-plugged tape drives, or newly -configured or deleted logical drives) and notify the SCSI mid-layer of +configured or deleted logical volumes) and notify the SCSI mid-layer of any changes detected. Usually this action is triggered automatically by configuration changes, so the user should not normally have to write to this file. Doing so may be useful when hot-plugging devices such as tape drives or -entire storage boxes containing pre-configured logical drives. -.TP -.IR /sys/class/scsi_host/host * /version -The host -.I version -attribute is a read-only attribute. -This attribute contains the driver version and the controller firmware -version. -.IP -For example: -.IP -.in +4n -.EX -$ \c -.B cat /sys/class/scsi_host/host1/version -driver: 1.1.2\-126 -firmware: 1.29\-112 -.EE +entire storage boxes containing pre-configured logical volumes. .in .TP .IR /sys/class/scsi_host/host * /lockup_action -- 2.42.0.296.g493f462273
