Hi William,
On 14/08/23 23:18, William R Sowerbutts wrote:
On Mon, Aug 14, 2023 at 10:54:54AM +1200, Michael Schmitz wrote:
On 14/08/23 10:24, William R Sowerbutts wrote:
* 6.4.10 + Michael's RFC patch -- IDE fails (no crash, but "Bad IO
access")
That might be fixed by my second RFC patch, just gone out today.
6.4.10 + your "RFC v2" patch boots without the "Bad IO access" errors!
Your patch looks correct to me.
Thanks - I'll look into whether we can use CONFIG_HAS_IOPORT_MAP without
any ill effects now (or wheher our own ioport_map() must be modified to
add the IO token on Q40).
This one still byte-swaps the data from disk though. I understood that was
always the case for Q40, but I may have been mistaken there.
It is indeed returning byte-swapped data. This is easily fixed, I'm using
the attached patch.
For my 6.4 patch I enabled byte swapping in the pata_falcon_data_xfer()
function -- this allows me to use an IDE drive with everything in the
normal/compatible byte ordering, which makes life much easier. I assume this
is the intended behaviour.
That would be the sane behaviour, but the designers of both the Falcon and
apparently the TiVo decided otherwise, wired up the IDE data bus byte-swapped
and saved the byteswap operations in the driver. I'm unsure how this was
intended to work on Q40.
The Q40 does NOT have hardware to reverse the byte-swapping. The CPU has to
byte-swap data if you want to use disks with standard/compatible data.
I understand that - the issue was (and is) whether byte swapping by CPU
is required in order to support legacy disks, or not.
Now the question is how data on legacy Q40 IDE disks have been stored. If
it's byte-swapped, we'd better keep that byte order in the current driver
(meaning your changes to pata_falcon_data_xfer() won't be needed, but you
would have to swap back data on your disk). If it's always been in PC
compatible byte order, all data (not just the identify data) must be swapped.
I'd like to have Richard's opinion on this (or hear from any other former Q40
user).
I have learned that the "standard" firmware for the Q40, SMSQ/E, does not
byte-swap data (it also uses an obscure partition scheme and filesystem).
Thanks, that's what I was worried about.
Personally, I am strongly in favour of Linux on the Q40 using standard
byte-order disks that are compatible with other machines. This feels like the
right thing to do and it is what I think most users would expect.
Yes, but ...
Users (if there are any!) with legacy byte-swapped disks can always use the
standard tools to byte swap them into the correct, compatible format.
That would make these disks impossible to use by the default firmware
though.
As ugly as it may be, I think we'll need a module parameter (or Q40 boot
option) to switch the driver to legacy disk mode here. That could be
always set for Falcon, and set on demand for Q40 so we save the
MACH_IS_Q40 test on each data transfer.
Cheers,
Michael
Thanks
Will
_________________________________________________________________________
William R Sowerbutts will@xxxxxxxxxxxxxx
"Carpe post meridiem" http://sowerbutts.com
main(){char*s=">#=0> ^#X@#@^7=",c=0,m;for(;c<15;c++)for
(m=-1;m<7;putchar(m++/6&c%3/2?10:s[c]-31&1<<m?42:32));}
