On Thu, 5 May 2022, Arnd Bergmann wrote:
I'm hearing that generic powerpc kernels have to run both on machines
that have I/O port space and those that don't. That makes me think
s390 could do something similar.
No, this is actually the current situation, and it makes absolutely no
sense. s390 has no way of implementing inb()/outb() because there
are no instructions for it and it cannot tunnel them through a virtual
address mapping like on most of the other architectures. (it has special
instructions for accessing memory space, which is not the same as
a pointer dereference here).
I think I'm missing something here. IIUC we're talking about a PCI/PCIe
bus used with s390 hardware, right?
(It has to be PCI/PCIe, because other than x86/IA-64 host buses there are
only PCI/PCIe and EISA/ISA buses out there that define I/O access cycles
and EISA/ISA have long been obsoleted except perhaps from some niche use.)
If this is PCI/PCIe indeed, then an I/O access is just a different bit
pattern put on the bus/in the TLP in the address phase. So what is there
inherent to the s390 architecture that prevents that different bit pattern
from being used?
If anything, I could imagine the same limitation as with current POWER9
implementations, that is whatever glue is used to wire PCI/PCIe to the
rest of the system does not implement a way to use said bit pattern (which
has nothing to do with the POWER9 processor instruction set).
But that has nothing to do with the presence or absence of any specific
processor instructions. It's just a limitation of bus glue. So I guess
it's just that all PCI/PCIe glue logic implementations for s390 have such
a limitation, right?
Maciej
