After some unsuccessful attempts to use sysrq over console, figured out that port->has_sysrq should likely be enabled, as per other architectures, this when CONFIG_SERIAL_MCF_CONSOLE is also enabled. Tested some magic sysrq commands (h, p, t, b), they works now properly. Commands works inside 5 secs after BREAK is sent, as expected. Signed-off-by: Angelo Dureghello <angelo.dureghello@xxxxxxxxxxx> --- drivers/tty/serial/mcf.c | 1 + 1 file changed, 1 insertion(+) diff --git a/drivers/tty/serial/mcf.c b/drivers/tty/serial/mcf.c index 7dbfb4cde124..09c88c48fb7b 100644 --- a/drivers/tty/serial/mcf.c +++ b/drivers/tty/serial/mcf.c @@ -632,6 +632,7 @@ static int mcf_probe(struct platform_device *pdev) port->ops = &mcf_uart_ops; port->flags = UPF_BOOT_AUTOCONF; port->rs485_config = mcf_config_rs485; + port->has_sysrq = IS_ENABLED(CONFIG_SERIAL_MCF_CONSOLE); uart_add_one_port(&mcf_driver, port); } -- 2.28.0
