On Wed, Jun 10, 2020 at 05:48:11PM +0200, Gerald Schaefer wrote:
Hi,
Hi, Gerald,
Some architectures have their page fault accounting code inside the fault
retry loop, and rely on only going through that code once. Before commit
4064b9827063 ("mm: allow VM_FAULT_RETRY for multiple times"), that was
ensured by testing for and clearing FAULT_FLAG_ALLOW_RETRY.
That commit had to remove the clearing of FAULT_FLAG_ALLOW_RETRY for all
architectures, and introduced a subtle change to page fault accounting
logic in the affected archs. It is now possible to go through the retry
loop multiple times, and the affected archs would then account multiple
page faults instead of just one.
This was found by coincidence in s390 code, and a quick check showed that
there are quite a lot of other architectures that seem to be affected in a
similar way. I'm preparing a fix for s390, by moving the accounting behind
the retry loop, similar to x86. It is not completely straight-forward, so
I leave the fix for other archs to the respective maintainers.
Sorry for not noticing this before. The accounting part should definitely be
put at least into a check against fault_flag_allow_retry_first() to mimic what
was done before. And I agree it would be even better to put it after the retry
logic, so if any of the page faults gets a major fault, it'll be accounted as a
major fault which makes more sense to me, just like what x86 is doing now with:
major |= fault & VM_FAULT_MAJOR;
I'm not sure what's the preference of the arch maintainers, just let me know if
it's preferred to use a single series to address this issue for all affected
archs (or the archs besides s390), then I'll do.
Thanks!
--
Peter Xu
