Hi Angelo,
On 13/5/19 5:41 am, Angelo Dureghello wrote:
Signed-off-by: Angelo Dureghello <angelo@xxxxxxxx>
---
drivers/mmc/host/Kconfig | 13 +++++++++++++
drivers/mmc/host/Makefile | 3 +++
2 files changed, 16 insertions(+)
diff --git a/drivers/mmc/host/Kconfig b/drivers/mmc/host/Kconfig
index 0e86340536b6..91007572a097 100644
--- a/drivers/mmc/host/Kconfig
+++ b/drivers/mmc/host/Kconfig
@@ -220,6 +220,19 @@ config MMC_SDHCI_CNS3XXX
If unsure, say N.
+config MMC_SDHCI_ESDHC_MCF
+ tristate "SDHCI support for the Freescale eSDHC ColdFire controller"
+ depends on M5441x
+ depends on MMC_SDHCI_PLTFM
+ select MMC_SDHCI_IO_ACCESSORS
+ help
+ This selects the Freescale eSDHC/uSDHC controller support
+ found on i.MX25, i.MX35 i.MX5x and i.MX6x.
So you copied/pasted this from the entry for the MMC_SDHCI_ESDHC_IMX driver?
I have not looked at the hardware module of the SHDC controller in
the ColdFire parts, but is it in any way similar or the same as
Freescale uses in the iMX families?
Regards
Greg
+ If you have a controller with this interface, say Y or M here.
+
+ If unsure, say N.
+
config MMC_SDHCI_ESDHC_IMX
tristate "SDHCI support for the Freescale eSDHC/uSDHC i.MX controller"
depends on ARCH_MXC
diff --git a/drivers/mmc/host/Makefile b/drivers/mmc/host/Makefile
index 73578718f119..17c3826dfe81 100644
--- a/drivers/mmc/host/Makefile
+++ b/drivers/mmc/host/Makefile
@@ -80,6 +80,7 @@ obj-$(CONFIG_MMC_REALTEK_USB) += rtsx_usb_sdmmc.o
obj-$(CONFIG_MMC_SDHCI_PLTFM) += sdhci-pltfm.o
obj-$(CONFIG_MMC_SDHCI_CADENCE) += sdhci-cadence.o
obj-$(CONFIG_MMC_SDHCI_CNS3XXX) += sdhci-cns3xxx.o
+obj-$(CONFIG_MMC_SDHCI_ESDHC_MCF) += sdhci-esdhc-mcf.o
obj-$(CONFIG_MMC_SDHCI_ESDHC_IMX) += sdhci-esdhc-imx.o
obj-$(CONFIG_MMC_SDHCI_DOVE) += sdhci-dove.o
obj-$(CONFIG_MMC_SDHCI_TEGRA) += sdhci-tegra.o
@@ -104,3 +105,5 @@ endif
obj-$(CONFIG_MMC_SDHCI_XENON) += sdhci-xenon-driver.o
sdhci-xenon-driver-y += sdhci-xenon.o sdhci-xenon-phy.o
+
+CFLAGS_sdhci-esdhc-mcf.o := -DDEBUG
