From: Greg Ungerer <gerg@xxxxxxxxxxx>
Simplify the UART setup code so that it no longer loops for each UART
present. Just make it do all the work it needs in a single function.
This will make the code easier to share when we move to a single set
of platform data for ColdFire UARTs.
Signed-off-by: Greg Ungerer <gerg@xxxxxxxxxxx>
---
arch/m68k/platform/5272/config.c | 27 ++++++++-------------------
1 files changed, 8 insertions(+), 19 deletions(-)
diff --git a/arch/m68k/platform/5272/config.c b/arch/m68k/platform/5272/config.c
index 99b499e..9074411 100644
--- a/arch/m68k/platform/5272/config.c
+++ b/arch/m68k/platform/5272/config.c
@@ -85,29 +85,18 @@ static struct platform_device *m5272_devices[] __initdata = {
/***************************************************************************/
-static void __init m5272_uart_init_line(int line, int irq)
+static void __init m5272_uarts_init(void)
{
u32 v;
- if ((line >= 0) && (line < 2)) {
- /* Enable the output lines for the serial ports */
- v = readl(MCF_MBAR + MCFSIM_PBCNT);
- v = (v & ~0x000000ff) | 0x00000055;
- writel(v, MCF_MBAR + MCFSIM_PBCNT);
-
- v = readl(MCF_MBAR + MCFSIM_PDCNT);
- v = (v & ~0x000003fc) | 0x000002a8;
- writel(v, MCF_MBAR + MCFSIM_PDCNT);
- }
-}
-
-static void __init m5272_uarts_init(void)
-{
- const int nrlines = ARRAY_SIZE(m5272_uart_platform);
- int line;
+ /* Enable the output lines for the serial ports */
+ v = readl(MCF_MBAR + MCFSIM_PBCNT);
+ v = (v & ~0x000000ff) | 0x00000055;
+ writel(v, MCF_MBAR + MCFSIM_PBCNT);
- for (line = 0; (line < nrlines); line++)
- m5272_uart_init_line(line, m5272_uart_platform[line].irq);
+ v = readl(MCF_MBAR + MCFSIM_PDCNT);
+ v = (v & ~0x000003fc) | 0x000002a8;
+ writel(v, MCF_MBAR + MCFSIM_PDCNT);
}
/***************************************************************************/
--
1.7.0.4
--
To unsubscribe from this list: send the line "unsubscribe linux-m68k" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
