On 10/3/24 1:21 AM, Andrew Lunn wrote:
On Tue, Oct 01, 2024 at 04:45:23AM +0200, Marek Vasut wrote:
The trigger_data->hw_control indicates whether the LED is controlled by HW
offload, i.e. the PHY. The trigger_data->hw_control = can_hw_control() is
currently called only from netdev_led_attr_store(), i.e. when writing any
sysfs attribute of the netdev trigger instance associated with a PHY LED.
The can_hw_control() calls validate_net_dev() which internally calls
led_cdev->hw_control_get_device(), which is phy_led_hw_control_get_device()
for PHY LEDs. The phy_led_hw_control_get_device() returns NULL if the PHY
is not attached.
At least in case of DWMAC (STM32MP, iMX8M, ...), the PHY device is attached
only when the interface is brought up and is detached again when the
interface is brought down. In case e.g. udev rules configure the netdev
LED trigger sysfs attributes before the interface is brought up, then when
the interface is brought up, the LEDs are not blinking.
This is because trigger_data->hw_control = can_hw_control() was called
when udev wrote the sysfs attribute files, before the interface was up,
so can_hw_control() resp. validate_net_dev() returned false, and the
trigger_data->hw_control = can_hw_control() was never called again to
update the trigger_data->hw_control content and let the offload take
over the LED blinking.
Call data->hw_control = can_hw_control() from netdev_trig_notify() to
update the offload capability of the LED when the UP notification arrives.
This makes the LEDs blink after the interface is brought up.
Have you run this code with lockdep enabled? There have been some
deadlocks, or potential deadlocks in this area.
Now I did on next 20241002 , no lockdep splat reported .
On STM32MP13xx with RTL8211F, it is enough to have the following udev rule
in place, boot the machine with cable plugged in, and the LEDs won't work
without this patch once the interface is brought up, even if they should:
"
ACTION=="add", SUBSYSTEM=="leds", KERNEL=="stmmac-0:01:green:wan", ATTR{trigger}="netdev", ATTR{link_10}="1", ATTR{link_100}="1", ATTR{link_1000}="1", ATTR{device_name}="end0"
ACTION=="add", SUBSYSTEM=="leds", KERNEL=="stmmac-0:01:yellow:wan", ATTR{trigger}="netdev", ATTR{rx}="1", ATTR{tx}="1", ATTR{device_name}="end0"
"
Nice use of udev. I had not thought about using it for this.
Is there some other way to configure the netdev-triggered PHY LEDs ?
I still feel the udev rule is somewhat brittle and fragile, and also not
available early enough for default PHY LED configuration, i.e. the LEDs
are not blinking when I use e.g. ip=/nfsroot= when booting from NFS root
until the userspace started, which is not nice. The only alternative I
can imagine is default configuration in DT, which was already rejected a
few years ago.
