Hello Christian,
On Thu, 4 Jan 2024 12:01:12 +0100
Christian Marangi <ansuelsmth@xxxxxxxxx> wrote:
> Add LED support for QCA8081 PHY.
>
> Documentation for this LEDs PHY is very scarce even with NDA access
> to Documentation for OEMs. Only the blink pattern are documented and are
> very confusing most of the time. No documentation is present about
> forcing the LED on/off or to always blink.
>
> Those settings were reversed by poking the regs and trying to find the
> correct bits to trigger these modes. Some bits mode are not clear and
> maybe the documentation option are not 100% correct. For the sake of LED
> support the reversed option are enough to add support for current LED
> APIs.
I have one small comment below :
> +static int qca808x_led_blink_set(struct phy_device *phydev, u8 index,
> + unsigned long *delay_on,
> + unsigned long *delay_off)
> +{
> + int ret;
> + u16 reg;
> +
> + if (index > 2)
> + return -EINVAL;
> +
> + reg = QCA808X_MMD7_LED_FORCE_CTRL(index);
> +
> + /* Set blink to 50% off, 50% on at 4Hz by default */
> + ret = phy_modify_mmd(phydev, MDIO_MMD_AN, QCA808X_MMD7_LED_GLOBAL,
> + QCA808X_LED_BLINK_FREQ_MASK | QCA808X_LED_BLINK_DUTY_MASK,
> + QCA808X_LED_BLINK_FREQ_256HZ | QCA808X_LED_BLINK_DUTY_50_50);
The comment (4Hz) and the blink frequency (256Hz) don't match, is that
right ? because I see there exists a QCA808X_LED_BLINK_FREQ_4HZ
definition, shouldn't it be used ?
Thanks,
Maxime
