Re: [PATCH v5 02/11] leds: aw200xx: support HWEN hardware control

[Andy Shevchenko <andy.shevchenko@xxxxxxxxx>]

On Sat, Nov 25, 2023 at 10:05 PM Dmitry Rokosov
<ddrokosov@xxxxxxxxxxxxxxxxx> wrote:
>
> HWEN is hardware control, which is used for enable/disable aw200xx chip.
> It's high active, internally pulled down to GND.
>
> After HWEN pin set high the chip begins to load the OTP information,
> which takes 200us to complete. About 200us wait time is needed for
> internal oscillator startup and display SRAM initialization. After
> display SRAM initialization, the registers in page 1 to page 5 can be
> configured via i2c interface.

...

> +       chip->hwen = devm_gpiod_get_optional(&client->dev, "enable",
> +                                            GPIOD_OUT_HIGH);
> +       if (IS_ERR(chip->hwen))
> +               return dev_err_probe(&client->dev, PTR_ERR(chip->hwen),
> +                                    "Cannot get enable GPIO");

You can make it neater with

  struct device *dev = &client->dev;

-- 
With Best Regards,
Andy Shevchenko