From: George Stark <gnstark@xxxxxxxxxxxxxxxxx>
Get rid of the property "awinic,display-rows" and calculate it
in the driver using led definition nodes.
Signed-off-by: George Stark <gnstark@xxxxxxxxxxxxxxxxx>
Signed-off-by: Dmitry Rokosov <ddrokosov@xxxxxxxxxxxxxxxxx>
Acked-by: Rob Herring <robh@xxxxxxxxxx>
---
.../bindings/leds/awinic,aw200xx.yaml | 28 +++----------------
1 file changed, 4 insertions(+), 24 deletions(-)
diff --git a/Documentation/devicetree/bindings/leds/awinic,aw200xx.yaml b/Documentation/devicetree/bindings/leds/awinic,aw200xx.yaml
index 3da3633a242c..a6dced59599d 100644
--- a/Documentation/devicetree/bindings/leds/awinic,aw200xx.yaml
+++ b/Documentation/devicetree/bindings/leds/awinic,aw200xx.yaml
@@ -36,11 +36,6 @@ properties:
"#size-cells":
const: 0
- awinic,display-rows:
- $ref: /schemas/types.yaml#/definitions/uint32
- description:
- Leds matrix size
-
enable-gpios:
maxItems: 1
@@ -63,31 +58,17 @@ patternProperties:
since the chip has a single global setting.
The maximum output current of each LED is calculated by the
following formula:
- IMAXled = 160000 * (592 / 600.5) * (1 / display-rows)
+ IMAXled = 160000 * (592 / 600.5) * (1 / max-current-switch-number)
And the minimum output current formula:
- IMINled = 3300 * (592 / 600.5) * (1 / display-rows)
+ IMINled = 3300 * (592 / 600.5) * (1 / max-current-switch-number)
+ where max-current-switch-number is determinated by led configuration
+ and depends on how leds are physically connected to the led driver.
required:
- compatible
- reg
- "#address-cells"
- "#size-cells"
- - awinic,display-rows
-
-allOf:
- - if:
- properties:
- compatible:
- contains:
- const: awinic,aw20036
- then:
- properties:
- awinic,display-rows:
- enum: [1, 2, 3]
- else:
- properties:
- awinic,display-rows:
- enum: [1, 2, 3, 4, 5, 6, 7]
additionalProperties: false
@@ -105,7 +86,6 @@ examples:
reg = <0x3a>;
#address-cells = <1>;
#size-cells = <0>;
- awinic,display-rows = <3>;
enable-gpios = <&gpio 3 GPIO_ACTIVE_HIGH>;
led@0 {
--
2.36.0
