This series adds support for blinking using the PCA955x chip, falling back to software blinking if another LED on the chip is already blinking at a different rate, or if the requested rate isn't representable with the PCA955x. Also included are some minor clean up and optimization changes that make the HW blinking a bit easier. Changes since v6: - Fix erroneous return value check of smbus block read Changes since v5: - Use auto-incrementing control register to read all the led selectors at once during initialization Changes since v4: - Set duty cycle to fifty percent for blinked LEDs in order to maintain the specified blink rate. Changes since v3: - Initialize return value in the blink function Thanks Dan Carpenter and kernel test robot Changes since v2: - Split the cleanup patch - Prettier dev_err calls - Include units for blink period and use defined unit translations rather than just a number. - Use positive conditionals. Changes since v1: - Rework the blink function to fallback to software blinking if the period is out of range of the chip's capabilities or if another LED on the chip is already blinking at a different rate. - Add the cleanup patch Eddie James (4): leds: pca955x: Refactor with helper functions and renaming leds: pca955x: Use pointers to driver data rather than I2C client leds: pca955x: Optimize probe led selection leds: pca955x: Add HW blink support drivers/leds/leds-pca955x.c | 350 ++++++++++++++++++++++++------------ 1 file changed, 239 insertions(+), 111 deletions(-) -- 2.31.1
