[PATCH RESEND 3/5] dt-bindings: leds: add Ethernet triggered LEDs to example

[Rafał Miłecki <zajec5@xxxxxxxxx>]

From: Rafał Miłecki <rafal@xxxxxxxxxx>

This adds 3 entries to existing example:
1. LED triggered by switch port in 10 / 100 Mbps link state
2. LED triggered by switch port in 1000 Mbps link
3. LED triggered by Ethernet interface (any speed)

Signed-off-by: Rafał Miłecki <rafal@xxxxxxxxxx>
---
 .../devicetree/bindings/leds/common.yaml      | 21 +++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/Documentation/devicetree/bindings/leds/common.yaml b/Documentation/devicetree/bindings/leds/common.yaml
index 328952d7acbb..6c72121a1656 100644
--- a/Documentation/devicetree/bindings/leds/common.yaml
+++ b/Documentation/devicetree/bindings/leds/common.yaml
@@ -168,6 +168,7 @@ examples:
   - |
     #include <dt-bindings/gpio/gpio.h>
     #include <dt-bindings/leds/common.h>
+    #include <dt-bindings/net/eth.h>
 
     led-controller {
         compatible = "gpio-leds";
@@ -183,6 +184,26 @@ examples:
             gpios = <&gpio0 1 GPIO_ACTIVE_HIGH>;
             trigger-sources = <&ohci_port1>, <&ehci_port1>;
         };
+
+        led-2 {
+            function = LED_FUNCTION_WAN;
+            color = <LED_COLOR_ID_AMBER>;
+            gpios = <&gpio0 2 GPIO_ACTIVE_LOW>;
+            trigger-sources = <&wan_port (SPEED_10 | SPEED_100)>;
+        };
+
+        led-3 {
+            function = LED_FUNCTION_WAN;
+            color = <LED_COLOR_ID_GREEN>;
+            gpios = <&gpio0 3 GPIO_ACTIVE_LOW>;
+            trigger-sources = <&wan_port SPEED_1000>;
+        };
+
+        led-4 {
+            function = LED_FUNCTION_LAN;
+            gpios = <&gpio0 4 GPIO_ACTIVE_LOW>;
+            trigger-sources = <&gmac 0>;
+        };
     };
 
   - |
-- 
2.34.1