On Tue, Apr 19, 2022 at 6:41 PM Arnd Bergmann <arnd@xxxxxxxxxx> wrote:
> From: Arnd Bergmann <arnd@xxxxxxxx>
>
> The audio driver should not use a hardwired gpio number
> from the header. Change it to use a lookup table.
>
> Cc: Philipp Zabel <philipp.zabel@xxxxxxxxx>
> Cc: Paul Parsons <lost.distance@xxxxxxxxx>
> Acked-by: Mark Brown <broonie@xxxxxxxxxx>
> Acked-by: Robert Jarzmik <robert.jarzmik@xxxxxxx>
> Cc: alsa-devel@xxxxxxxxxxxxxxxx
> Signed-off-by: Arnd Bergmann <arnd@xxxxxxxx>
(...)
> +static struct gpiod_lookup_table hx4700_audio_gpio_table = {
> + .dev_id = "hx4700-audio",
> + .table = {
> + GPIO_LOOKUP("gpio-pxa", GPIO75_HX4700_EARPHONE_nDET,
> + "earphone-ndet", GPIO_ACTIVE_HIGH),
This looks wrong. The n in nDET in the end of the name of the GPIO line
means active low does it not?
What I usually do when I see this is to properly set it to
GPIO_ACTIVE_LOW in the descriptor table, then invert the logic
where it's getting used.
Also rename to earphone-det instead of -ndet
> + GPIO_LOOKUP("gpio-pxa", GPIO92_HX4700_HP_DRIVER,
> + "hp-driver", GPIO_ACTIVE_HIGH),
> + GPIO_LOOKUP("gpio-pxa", GPIO107_HX4700_SPK_nSD,
> + "spk-nsd", GPIO_ACTIVE_HIGH),
Same here. Rename spk-sd
Yours,
Linus Walleij
