On 11/23/21 10:39 AM, Maxime Ripard wrote:
> On Fri, Nov 19, 2021 at 05:57:01PM -0600, Samuel Holland wrote:
>> Hi Maxime,
>>
>> On 11/19/21 2:28 AM, Maxime Ripard wrote:
>>> Hi,
>>>
>>> On Thu, Nov 18, 2021 at 11:40:43PM -0600, Samuel Holland wrote:
>>>> +static const struct sun50i_r329_ledc_timing sun50i_r329_ledc_default_timing = {
>>>> + .t0h_ns = 336,
>>>> + .t0l_ns = 840,
>>>> + .t1h_ns = 882,
>>>> + .t1l_ns = 294,
>>>> + .treset_ns = 300000,
>>>> +};
>>>
>>> This should be mentioned in the binding as well (using the default keyword)
>>
>> Ok, I'll do this for v4.
>>
>>>> +static int sun50i_r329_ledc_parse_timing(const struct device_node *np,
>>>> + struct sun50i_r329_ledc *priv)
>>>> +{
>>>> + struct sun50i_r329_ledc_timing *timing = &priv->timing;
>>>> +
>>>> + *timing = sun50i_r329_ledc_default_timing;
>>>> +
>>>> + of_property_read_u32(np, "allwinner,t0h-ns", &timing->t0h_ns);
>>>> + of_property_read_u32(np, "allwinner,t0l-ns", &timing->t0l_ns);
>>>> + of_property_read_u32(np, "allwinner,t1h-ns", &timing->t1h_ns);
>>>> + of_property_read_u32(np, "allwinner,t1l-ns", &timing->t1l_ns);
>>>> + of_property_read_u32(np, "allwinner,treset-ns", &timing->treset_ns);
>>>> +
>>>> + return 0;
>>>> +}
>>>> +
>>>> +static void sun50i_r329_ledc_set_timing(struct sun50i_r329_ledc *priv)
>>>> +{
>>>> + const struct sun50i_r329_ledc_timing *timing = &priv->timing;
>>>> + unsigned long mod_freq = clk_get_rate(priv->mod_clk);
>>>> + u32 cycle_ns = NSEC_PER_SEC / mod_freq;
>>>> + u32 val;
>>>> +
>>>> + val = (timing->t1h_ns / cycle_ns) << 21 |
>>>> + (timing->t1l_ns / cycle_ns) << 16 |
>>>> + (timing->t0h_ns / cycle_ns) << 6 |
>>>> + (timing->t0l_ns / cycle_ns);
>>>> + writel(val, priv->base + LEDC_T01_TIMING_CTRL_REG);
>>>> +
>>>> + val = (timing->treset_ns / cycle_ns) << 16 |
>>>> + (priv->num_leds - 1);
>>>> + writel(val, priv->base + LEDC_RESET_TIMING_CTRL_REG);
>>>> +}
>>>> +
>>>> +static int sun50i_r329_ledc_resume(struct device *dev)
>>>> +{
>>>> + struct sun50i_r329_ledc *priv = dev_get_drvdata(dev);
>>>> + u32 val;
>>>> + int ret;
>>>> +
>>>> + ret = reset_control_deassert(priv->reset);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + ret = clk_prepare_enable(priv->bus_clk);
>>>> + if (ret)
>>>> + goto err_assert_reset;
>>>> +
>>>> + ret = clk_prepare_enable(priv->mod_clk);
>>>> + if (ret)
>>>> + goto err_disable_bus_clk;
>>>> +
>>>> + sun50i_r329_ledc_set_format(priv);
>>>> + sun50i_r329_ledc_set_timing(priv);
>>>> +
>>>> + /* The trigger level must be at least the burst length. */
>>>> + val = readl(priv->base + LEDC_DMA_CTRL_REG);
>>>> + val &= ~LEDC_DMA_CTRL_REG_FIFO_TRIG_LEVEL;
>>>> + val |= LEDC_FIFO_DEPTH / 2;
>>>> + writel(val, priv->base + LEDC_DMA_CTRL_REG);
>>>> +
>>>> + val = LEDC_INT_CTRL_REG_GLOBAL_INT_EN |
>>>> + LEDC_INT_CTRL_REG_TRANS_FINISH_INT_EN;
>>>> + writel(val, priv->base + LEDC_INT_CTRL_REG);
>>>> +
>>>> + return 0;
>>>> +
>>>> +err_disable_bus_clk:
>>>> + clk_disable_unprepare(priv->bus_clk);
>>>> +err_assert_reset:
>>>> + reset_control_assert(priv->reset);
>>>> +
>>>> + return ret;
>>>> +}
>>>> +
>>>> +static int sun50i_r329_ledc_suspend(struct device *dev)
>>>> +{
>>>> + struct sun50i_r329_ledc *priv = dev_get_drvdata(dev);
>>>> +
>>>> + clk_disable_unprepare(priv->mod_clk);
>>>> + clk_disable_unprepare(priv->bus_clk);
>>>> + reset_control_assert(priv->reset);
>>>> +
>>>> + return 0;
>>>> +}
>>>> +
>>>> +static void sun50i_r329_ledc_dma_cleanup(void *data)
>>>> +{
>>>> + struct sun50i_r329_ledc *priv = data;
>>>> + struct device *dma_dev = dmaengine_get_dma_device(priv->dma_chan);
>>>> +
>>>> + if (priv->buffer)
>>>> + dma_free_wc(dma_dev, LEDS_TO_BYTES(priv->num_leds),
>>>> + priv->buffer, priv->dma_handle);
>>>> + dma_release_channel(priv->dma_chan);
>>>> +}
>>>> +
>>>> +static int sun50i_r329_ledc_probe(struct platform_device *pdev)
>>>> +{
>>>> + const struct device_node *np = pdev->dev.of_node;
>>>> + struct dma_slave_config dma_cfg = {};
>>>> + struct led_init_data init_data = {};
>>>> + struct device *dev = &pdev->dev;
>>>> + struct device_node *child;
>>>> + struct sun50i_r329_ledc *priv;
>>>> + struct resource *mem;
>>>> + int count, irq, ret;
>>>> +
>>>> + count = of_get_available_child_count(np);
>>>> + if (!count)
>>>> + return -ENODEV;
>>>> + if (count > LEDC_MAX_LEDS) {
>>>> + dev_err(dev, "Too many LEDs! (max is %d)\n", LEDC_MAX_LEDS);
>>>> + return -EINVAL;
>>>> + }
>>>> +
>>>> + priv = devm_kzalloc(dev, struct_size(priv, leds, count), GFP_KERNEL);
>>>> + if (!priv)
>>>> + return -ENOMEM;
>>>> +
>>>> + priv->dev = dev;
>>>> + priv->num_leds = count;
>>>> + spin_lock_init(&priv->lock);
>>>> + dev_set_drvdata(dev, priv);
>>>> +
>>>> + ret = sun50i_r329_ledc_parse_format(np, priv);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + ret = sun50i_r329_ledc_parse_timing(np, priv);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + priv->base = devm_platform_get_and_ioremap_resource(pdev, 0, &mem);
>>>> + if (IS_ERR(priv->base))
>>>> + return PTR_ERR(priv->base);
>>>> +
>>>> + priv->bus_clk = devm_clk_get(dev, "bus");
>>>> + if (IS_ERR(priv->bus_clk))
>>>> + return PTR_ERR(priv->bus_clk);
>>>> +
>>>> + priv->mod_clk = devm_clk_get(dev, "mod");
>>>> + if (IS_ERR(priv->mod_clk))
>>>> + return PTR_ERR(priv->mod_clk);
>>>> +
>>>> + priv->reset = devm_reset_control_get_exclusive(dev, NULL);
>>>> + if (IS_ERR(priv->reset))
>>>> + return PTR_ERR(priv->reset);
>>>> +
>>>> + priv->dma_chan = dma_request_chan(dev, "tx");
>>>> + if (IS_ERR(priv->dma_chan))
>>>> + return PTR_ERR(priv->dma_chan);
>>>> +
>>>> + ret = devm_add_action_or_reset(dev, sun50i_r329_ledc_dma_cleanup, priv);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + dma_cfg.dst_addr = mem->start + LEDC_DATA_REG;
>>>> + dma_cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
>>>> + dma_cfg.dst_maxburst = LEDC_FIFO_DEPTH / 2;
>>>> + ret = dmaengine_slave_config(priv->dma_chan, &dma_cfg);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + priv->buffer = dma_alloc_wc(dmaengine_get_dma_device(priv->dma_chan),
>>>> + LEDS_TO_BYTES(priv->num_leds),
>>>> + &priv->dma_handle, GFP_KERNEL);
>>>> + if (!priv->buffer)
>>>> + return -ENOMEM;
>>>> +
>>>> + irq = platform_get_irq(pdev, 0);
>>>> + if (irq < 0)
>>>> + return irq;
>>>> +
>>>> + ret = devm_request_irq(dev, irq, sun50i_r329_ledc_irq,
>>>> + 0, dev_name(dev), priv);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + ret = sun50i_r329_ledc_resume(dev);
>>>> + if (ret)
>>>> + return ret;
>>>
>>> You seem to fill the runtime_pm hooks, but only call them directly and
>>> never enable runtime_pm on that device, is that intentional?
>>
>> Yes. I did not want to delay the initial version by adding runtime PM
>> (and debugging the refcounts) when the driver already works now.
>> However, I had runtime/system PM in mind while writing the driver.
>>
>> If you think it is too confusing, I could rename the functions to
>> something like sun50i_r329_ledc_hw_init / sun50i_r329_ledc_hw_exit.
>
> It's not really the functions themselves that are confusing but rather
> that you set them as runtime_pm hooks.
I do not set these functions as runtime PM hooks. SIMPLE_DEV_PM_OPS only sets
the system PM hooks, for "suspend to RAM and hibernation." Maybe you are
thinking of SET_RUNTIME_PM_OPS, which I do not use?
Regards,
Samuel
> If you plan on submitting it later on, I guess the easiest would just be
> to remove the sun50i_r329_ledc_pm structure, and then you'll just have
> to introduce it back with a call to pm_runtime_enable when it's ready
>
> Maxime
>
