Fixes an issue where previously 0 is used as a sentinel when
moving device tree configuration into the bank enable mask. This
prevented the first LED from being added to bank control.
Signed-off-by: DonDrews <donovancarldrews@xxxxxxxxx>
---
drivers/leds/leds-lp50xx.c | 10 ++++------
1 file changed, 4 insertions(+), 6 deletions(-)
diff --git a/drivers/leds/leds-lp50xx.c b/drivers/leds/leds-lp50xx.c
index 401df1e2e05d..45f56caea182 100644
--- a/drivers/leds/leds-lp50xx.c
+++ b/drivers/leds/leds-lp50xx.c
@@ -347,17 +347,15 @@ static int lp50xx_brightness_set(struct led_classdev *cdev,
return ret;
}
-static int lp50xx_set_banks(struct lp50xx *priv, u32 led_banks[])
+static int lp50xx_set_banks(struct lp50xx *priv, u32 led_banks[], int num_leds)
{
u8 led_config_lo, led_config_hi;
u32 bank_enable_mask = 0;
int ret;
int i;
- for (i = 0; i < priv->chip_info->max_modules; i++) {
- if (led_banks[i])
- bank_enable_mask |= (1 << led_banks[i]);
- }
+ for (i = 0; i < num_leds; i++)
+ bank_enable_mask |= (1 << led_banks[i]);
led_config_lo = bank_enable_mask;
led_config_hi = bank_enable_mask >> 8;
@@ -413,7 +411,7 @@ static int lp50xx_probe_leds(struct fwnode_handle *child, struct lp50xx *priv,
return ret;
}
- ret = lp50xx_set_banks(priv, led_banks);
+ ret = lp50xx_set_banks(priv, led_banks, num_leds);
if (ret) {
dev_err(priv->dev, "Cannot setup banked LEDs\n");
return ret;
--
2.17.1
