On Thu, Jun 3, 2021 at 1:01 PM Sander Vanheule <sander@xxxxxxxxxxxxx> wrote:
>
> The RTL8231 is implemented as an MDIO device, and provides a regmap
> interface for register access by the core and child devices.
>
> The chip can also be a device on an SMI bus, an I2C-like bus by Realtek.
> Since kernel support for SMI is limited, and no real-world SMI
> implementations have been encountered for this device, this is currently
> unimplemented. The use of the regmap interface should make any future
> support relatively straightforward.
>
> After reset, all pins are muxed to GPIO inputs before the pin drivers
> are enabled. This is done to prevent accidental system resets, when a
> pin is connected to the parent SoC's reset line.
>
> To provide different read and write semantics for the GPIO data
> registers, a secondary virtual register range is used to enable separate
> cacheing properties of pin input and output values.
caching
...
> +static int rtl8231_reg_read(void *context, unsigned int reg, unsigned int *val)
> +{
> + struct mdio_device *mdio_dev = context;
> + int ret;
> +
> + ret = mdiobus_read(mdio_dev->bus, mdio_dev->addr, RTL8231_REAL_REG(reg));
> +
> + if (ret < 0)
> + return ret;
> +
> + *val = ret & 0xffff;
> +
> + return 0;
> +}
> +
> +static int rtl8231_reg_write(void *context, unsigned int reg, unsigned int val)
> +{
> + struct mdio_device *mdio_dev = context;
> +
> + return mdiobus_write(mdio_dev->bus, mdio_dev->addr, RTL8231_REAL_REG(reg), val);
> +}
Hmm... Maybe we can amend regmap-mdio to avoid duplication of the
above? Something like xlate in gpio-regmap or so?
...
> + mdiodev->reset_gpio = devm_gpiod_get_optional(dev, "reset", GPIOD_OUT_LOW);
Missed
if (IS_ERR(mdiodev->reset_gpio))
return PTR_ERR(mdiodev->reset_gpio);
--
With Best Regards,
Andy Shevchenko
