Pavel Machek <pavel@xxxxxx> 於 2020年9月11日 週五 下午3:05寫道：
>
> Hi!
>
> > >+{
> > >+ struct mt6360_led *led = container_of(lcdev, struct mt6360_led, flash.led_cdev);
> > >+ struct mt6360_priv *priv = led->priv;
> > >+ u32 enable_mask = MT6360_TORCHEN_MASK | MT6360_FLCSEN_MASK(led->led_no);
> > >+ u32 val = (level) ? MT6360_FLCSEN_MASK(led->led_no) : 0;
> > >+ u32 prev = priv->fled_torch_used, curr;
> > >+ int ret;
> > >+
> > >+ dev_dbg(lcdev->dev, "[%d] brightness %d\n", led->led_no, level);
> > >+ if (priv->fled_strobe_used) {
> > >+ dev_warn(lcdev->dev, "Please disable strobe first [%d]\n", priv->fled_strobe_used);
> >
> > Doesn't hardware handle that? IOW, what happens when you have enabled
> > both torch and flash? If flash just overrides torch mode, than you
> > should not prevent enabling torch in this case.
>
> Yep, this is strange/confusing... and was reason why I asked for not
> supporting strobe from sysfs.
>
> Could I get you to remove code you are not commenting at when
> reviewing?
>
MT6360 FLED register define is STROBE_EN/TORCH_EN/CS1/CS2 (current
source) 4 bits.
The STROBE_EN/TORCH_EN is shared by FLED1 and FLED2.
If I want to enable FLED1 torch mode, I set TORCH_EN and CS1
If I want to enable FLED2 strobe mode, I set STROBE_EN and CS2
For example I set FLED1 torch, then I set FLED2 strobe.
When I set FLED2 strobe, I will see the strobe current is FLED2 add
FLED1 current which is not I want.
So I need disable FLED1 torch first.
Considering every circumstances is complicated when share same H/W
logic control.
And the other problem is torch mode switch to strobe mode needs ramp
time because strobe and torch mode can't be co-exist.
> > >+MODULE_AUTHOR("Gene Chen <gene_chen@xxxxxxxxxxx>");
> > >+MODULE_DESCRIPTION("MT6360 Led Driver");
>
> Led -> LED.
>
ACK
> Pavel
> --
> (english) http://www.livejournal.com/~pavelmachek
> (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
