Hi,
On Sun, Aug 23, 2020 at 05:08:45PM +0300, Dmitry Osipenko wrote:
> Battery could be connected to the controller and in this case controller
> will provide a battery-monitor function.
>
> The power-supplies phandle property is needed in order to describe the
> power supply which is used for charging of the battery, this allows to
> determine whither battery is charging or discharging, depending on the
> supply state.
>
> The monitored-battery phandle provides information about the battery cell
> characteristics.
I believe it would be better if you created a new binding document
instead of reusing this one -- the hardware part iseems to be a
different one and the firmware it runs seems to be behaving totally
differently than the usual ENE firmware [1].
[1] This eneec.c seems to be coming from ENE, so I'm assuming it's a
good enough description of how their firmware behaves:
https://git.kernel.org/pub/scm/linux/kernel/git/lkundrak/linux-mmp3-dell-ariel.git/tree/drivers/input/serio/eneec.c
Cheers
Lubo
> Signed-off-by: Dmitry Osipenko <digetx@xxxxxxxxx>
> ---
> .../devicetree/bindings/mfd/ene-kb3930.yaml | 18 ++++++++++++++++++
> 1 file changed, 18 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/mfd/ene-kb3930.yaml b/Documentation/devicetree/bindings/mfd/ene-kb3930.yaml
> index 5a1c4a959d9c..435728054f3a 100644
> --- a/Documentation/devicetree/bindings/mfd/ene-kb3930.yaml
> +++ b/Documentation/devicetree/bindings/mfd/ene-kb3930.yaml
> @@ -29,6 +29,8 @@ properties:
> description: GPIO used with the shutdown protocol on Ariel
> maxItems: 2
>
> + monitored-battery: true
> + power-supplies: true
> system-power-controller: true
>
> required:
> @@ -41,6 +43,19 @@ examples:
> - |
> #include <dt-bindings/gpio/gpio.h>
>
> + battery: battery-cell {
> + compatible = "simple-battery";
> + charge-full-design-microamp-hours = <3260000>;
> + energy-full-design-microwatt-hours = <24000000>;
> + operating-range-celsius = <0 40>;
> + };
> +
> + mains: ac-adapter {
> + compatible = "gpio-charger";
> + charger-type = "mains";
> + gpios = <&gpio 125 GPIO_ACTIVE_LOW>;
> + };
> +
> i2c {
> #address-cells = <1>;
> #size-cells = <0>;
> @@ -52,6 +67,9 @@ examples:
>
> off-gpios = <&gpio 126 GPIO_ACTIVE_HIGH>,
> <&gpio 127 GPIO_ACTIVE_HIGH>;
> +
> + monitored-battery = <&battery>;
> + power-supplies = <&mains>;
> };
> };
>
> --
> 2.27.0
>
