Pavel On 10/11/2018 01:27 PM, Pavel Machek wrote: > On Thu 2018-10-11 11:51:16, Dan Murphy wrote: >> Remove support for the LM3697 LED device >> from the ti-lmu. The LM3697 will be supported >> via a stand alone LED driver. >> >> Signed-off-by: Dan Murphy <dmurphy@xxxxxx> > > NAK. Thanks for the NAK. This NAK was NAK'd by other maintainer in the V2 RFC patchset https://lore.kernel.org/patchwork/patch/993171/ > > Pavel > >> index c885cf89b8ce..920f910be4e9 100644 >> --- a/Documentation/devicetree/bindings/mfd/ti-lmu.txt >> +++ b/Documentation/devicetree/bindings/mfd/ti-lmu.txt >> @@ -9,7 +9,6 @@ TI LMU driver supports lighting devices below. >> LM3632 Backlight and regulator >> LM3633 Backlight, LED and fault monitor >> LM3695 Backlight >> - LM3697 Backlight and fault monitor >> >> Required properties: >> - compatible: Should be one of: >> @@ -18,11 +17,10 @@ Required properties: >> "ti,lm3632" >> "ti,lm3633" >> "ti,lm3695" >> - "ti,lm3697" >> - reg: I2C slave address. >> 0x11 for LM3632 >> 0x29 for LM3631 >> - 0x36 for LM3633, LM3697 >> + 0x36 for LM3633 >> 0x38 for LM3532 >> 0x63 for LM3695 >> >> @@ -38,7 +36,6 @@ Optional nodes: >> Required properties: >> - compatible: Should be one of: >> "ti,lm3633-fault-monitor" >> - "ti,lm3697-fault-monitor" >> - leds: LED properties for LM3633. Please refer to [2]. >> - regulators: Regulator properties for LM3631 and LM3632. >> Please refer to [3]. >> @@ -220,24 +217,3 @@ lm3695@63 { >> }; >> }; >> }; >> - >> -lm3697@36 { >> - compatible = "ti,lm3697"; >> - reg = <0x36>; >> - >> - enable-gpios = <&pioC 2 GPIO_ACTIVE_HIGH>; >> - >> - backlight { >> - compatible = "ti,lm3697-backlight"; >> - >> - lcd { >> - led-sources = <0 1 2>; >> - ramp-up-msec = <200>; >> - ramp-down-msec = <200>; >> - }; >> - }; >> - >> - fault-monitor { >> - compatible = "ti,lm3697-fault-monitor"; >> - }; >> -}; > -- ------------------ Dan Murphy
