The patch 'backlight: pwm_bl: compute brightness of LED linearly to
human eye' introduced a default brightness-levels table that is used
when brightness-levels is not availablel in the dts so move move
brightness-levels and default-brightness-level to be optional.
Signed-off-by: Enric Balletbo i Serra <enric.balletbo@xxxxxxxxxxxxx>
---
.../devicetree/bindings/leds/backlight/pwm-backlight.txt | 15 ++++++++-------
1 file changed, 8 insertions(+), 7 deletions(-)
diff --git a/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt b/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt
index 605432c910c5..3d5a148bd66d 100644
--- a/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt
+++ b/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt
@@ -3,13 +3,6 @@ pwm-backlight bindings
Required properties:
- compatible: "pwm-backlight"
- pwms: OF device-tree PWM specification (see PWM binding[0])
- - brightness-levels: Array of distinct brightness levels. Typically these
- are in the range from 0 to 255, but any range starting at 0 will do.
- The actual brightness level (PWM duty cycle) will be interpolated
- from these values. 0 means a 0% duty cycle (darkest/off), while the
- last value in the array represents a 100% duty cycle (brightest).
- - default-brightness-level: the default brightness level (index into the
- array defined by the "brightness-levels" property)
- power-supply: regulator for supply voltage
Optional properties:
@@ -21,6 +14,14 @@ Optional properties:
and enabling the backlight using GPIO.
- pwm-off-delay-ms: Delay in ms between disabling the backlight using GPIO
and setting PWM value to 0.
+ - brightness-levels: Array of distinct brightness levels. Typically these
+ are in the range from 0 to 255, but any range starting at
+ 0 will do. The actual brightness level (PWM duty cycle)
+ will be interpolated from these values. 0 means a 0% duty
+ cycle (darkest/off), while the last value in the array
+ represents a 100% duty cycle (brightest).
+ - default-brightness-level: The default brightness level (index into the
+ array defined by the "brightness-levels" property).
- num-interpolated-steps: Number of interpolated steps between each value
of brightness-levels table. This way a high
resolution pwm duty cycle can be used without
--
2.15.1
