The busy status checking isn't needed while reading initial LED status.
Signed-off-by: Álvaro Fernández Rojas <noltari@xxxxxxxxx>
---
drivers/leds/leds-bcm6358.c | 3 ---
1 file changed, 3 deletions(-)
diff --git a/drivers/leds/leds-bcm6358.c b/drivers/leds/leds-bcm6358.c
index 7413e3e..b2cc066 100644
--- a/drivers/leds/leds-bcm6358.c
+++ b/drivers/leds/leds-bcm6358.c
@@ -123,9 +123,6 @@ static int bcm6358_led(struct device *dev, struct device_node *nc, u32 reg,
led->cdev.brightness = LED_FULL;
} else if (!strcmp(state, "keep")) {
unsigned long val;
-
- bcm6358_led_busy(led->mem);
-
val = bcm6358_led_read(led->mem + BCM6358_REG_MODE);
val &= BIT(led->pin);
if ((led->active_low && !val) ||
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-leds" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
