On Thu, Nov 07, 2024 at 09:36:24AM +0000, Vladimir Vdovin wrote: > +test_pmtu_ipv4_mp_exceptions() { > + setup namespaces routing multipath || return $ksft_skip > + > + trace "${ns_a}" veth_A-R1 "${ns_r1}" veth_R1-A \ > + "${ns_r1}" veth_R1-B "${ns_b}" veth_B-R1 \ > + "${ns_a}" veth_A-R2 "${ns_r2}" veth_R2-A \ > + "${ns_r2}" veth_R2-B "${ns_b}" veth_B-R2 > + > + # Set up initial MTU values > + mtu "${ns_a}" veth_A-R1 2000 > + mtu "${ns_r1}" veth_R1-A 2000 > + mtu "${ns_r1}" veth_R1-B 1500 > + mtu "${ns_b}" veth_B-R1 1500 > + > + mtu "${ns_a}" veth_A-R2 2000 > + mtu "${ns_r2}" veth_R2-A 2000 > + mtu "${ns_r2}" veth_R2-B 1500 > + mtu "${ns_b}" veth_B-R2 1500 > + > + fail=0 > + > + # Ping and expect two nexthop exceptions for two routes in nh group > + run_cmd ${ns_a} ping -q -M want -i 0.1 -c 1 -s 1800 "${host4_b_addr}" > + > + # Do route lookup before checking cached exceptions. > + # The following commands are needed for dst entries to be cached > + # in both paths exceptions and therefore dumped to user space > + # Check that exceptions have been created with the correct PMTU > + pmtu_a_R1="$(route_get_dst_pmtu_from_exception "${ns_a}" "${host4_b_addr}" oif veth_A-R1)" > + pmtu_a_R2="$(route_get_dst_pmtu_from_exception "${ns_a}" "${host4_b_addr}" oif veth_A-R2)" > + In addition to the removal of 'fail=0' that you already mentioned, also need to flip the error messages: > + check_pmtu_value "1500" "${pmtu_a_R1}" "exceeding MTU (veth_A-R2)" || return 1 s/veth_A-R2/veth_A-R1/ > + check_pmtu_value "1500" "${pmtu_a_R2}" "exceeding MTU (veth_A-R1)" || return 1 s/veth_A-R1/veth_A-R2/ > +} > + > usage() { > echo > echo "$0 [OPTIONS] [TEST]..." > > base-commit: 66600fac7a984dea4ae095411f644770b2561ede > -- > 2.43.5 >