Richard Gobert wrote:
> {inet,ipv6}_gro_receive functions perform flush checks (ttl, flags,
> iph->id, ...) against all packets in a loop. These flush checks are used
> currently only in tcp flows in GRO.
>
> These checks need to be done only once in tcp_gro_receive and only against
> the found p skb, since they only affect flush and not same_flow.
I don't quite understand where the performance improvements arise.
As inet_gro_receive will skip any p that does not match:
if (!NAPI_GRO_CB(p)->same_flow)
continue;
iph2 = (struct iphdr *)(p->data + off);
/* The above works because, with the exception of the top
* (inner most) layer, we only aggregate pkts with the same
* hdr length so all the hdrs we'll need to verify will start
* at the same offset.
*/
if ((iph->protocol ^ iph2->protocol) |
((__force u32)iph->saddr ^ (__force u32)iph2->saddr) |
((__force u32)iph->daddr ^ (__force u32)iph2->daddr)) {
NAPI_GRO_CB(p)->same_flow = 0;
continue;
}
So these checks are already only performed against a p that matches.
> Leveraging the previous commit in the series, in which correct network
> header offsets are saved for both outer and inner network headers -
> allowing these checks to be done only once, in tcp_gro_receive. As a
Comments should be updated to reflect both TCP and L4 UDP. Can
generalize to transport callbacks.
> result, NAPI_GRO_CB(p)->flush is not used at all. In addition, flush_id
> checks are more declarative and contained in inet_gro_flush, thus removing
> the need for flush_id in napi_gro_cb.
>
> This results in less parsing code for UDP flows and non-loop flush tests
> for TCP flows.
This moves network layer tests out of the network layer callbacks into
helpers called from the transport layer callback. And then the helper
has to look up the network layer header and demultiplex the protocol
again:
+ if (((struct iphdr *)nh)->version == 6)
+ flush |= ipv6_gro_flush(nh, nh2);
+ else
+ flush |= inet_gro_flush(nh, nh2, p, i != encap_mark);
That just seems a bit roundabout.
