Several tests in the suite use large amounts of traffic to e.g. cause
congestion and evaluate RED or shaper performance. These tests will not run
well on a slow machine, be it one with heavy debug kernel, or a VM, or e.g.
a single-board computer. Allow users to specify an environment variable,
KSFT_MACHINE_SLOW=yes, to indicate that the tests are being run on one such
machine.
Performance sensitive tests can then use a new helper, xfail_on_slow(), to
mark parts of the test that are sensitive to low-performance machines.
The helper can be used to just mark the whole suite, like so:
xfail_on_slow tests_run
... or, on the other side of the granularity spectrum, to override
individual checks:
xfail_on_slow check_err $? "Expected much, got little."
Signed-off-by: Petr Machata <petrm@xxxxxxxxxx>
---
tools/testing/selftests/net/forwarding/lib.sh | 23 ++++++++++++++++++-
1 file changed, 22 insertions(+), 1 deletion(-)
diff --git a/tools/testing/selftests/net/forwarding/lib.sh b/tools/testing/selftests/net/forwarding/lib.sh
index 370fc377249b..58df57855bff 100644
--- a/tools/testing/selftests/net/forwarding/lib.sh
+++ b/tools/testing/selftests/net/forwarding/lib.sh
@@ -79,6 +79,11 @@ declare -A NETIFS=(
# Flags for TC filters.
: "${TC_FLAG:=skip_hw}"
+# Whether the machine is "slow" -- i.e. might be incapable of running tests
+# involving heavy traffic. This might be the case on a debug kernel, a VM, or
+# e.g. a low-power board.
+: "${KSFT_MACHINE_SLOW:=no}"
+
net_forwarding_dir=$(dirname "$(readlink -e "${BASH_SOURCE[0]}")")
if [[ -f $net_forwarding_dir/forwarding.config ]]; then
@@ -407,13 +412,20 @@ ret_set_ksft_status()
fi
}
+# Whether FAILs should be interpreted as XFAILs. Internal.
+FAIL_TO_XFAIL=
+
check_err()
{
local err=$1
local msg=$2
if ((err)); then
- ret_set_ksft_status $ksft_fail "$msg"
+ if [[ $FAIL_TO_XFAIL = yes ]]; then
+ ret_set_ksft_status $ksft_xfail "$msg"
+ else
+ ret_set_ksft_status $ksft_fail "$msg"
+ fi
fi
}
@@ -438,6 +450,15 @@ check_err_fail()
fi
}
+xfail_on_slow()
+{
+ if [[ $KSFT_MACHINE_SLOW = yes ]]; then
+ FAIL_TO_XFAIL=yes "$@"
+ else
+ "$@"
+ fi
+}
+
log_test_result()
{
local test_name=$1; shift
--
2.43.0
