Remove PEER_CMD, which is not used in this test
Here is the test result after conversion.
]# ./fib-onlink-tests.sh
Error: ipv4: FIB table does not exist.
Flush terminated
Error: ipv6: FIB table does not exist.
Flush terminated
########################################
Configuring interfaces
...
TEST: Gateway resolves to wrong nexthop device - VRF [ OK ]
Tests passed: 38
Tests failed: 0
Signed-off-by: Hangbin Liu <liuhangbin@xxxxxxxxx>
---
tools/testing/selftests/net/fib-onlink-tests.sh | 7 ++-----
1 file changed, 2 insertions(+), 5 deletions(-)
diff --git a/tools/testing/selftests/net/fib-onlink-tests.sh b/tools/testing/selftests/net/fib-onlink-tests.sh
index c287b90b8af8..8b04f8282480 100755
--- a/tools/testing/selftests/net/fib-onlink-tests.sh
+++ b/tools/testing/selftests/net/fib-onlink-tests.sh
@@ -3,6 +3,7 @@
# IPv4 and IPv6 onlink tests
+source lib.sh
PAUSE_ON_FAIL=${PAUSE_ON_FAIL:=no}
VERBOSE=0
@@ -74,9 +75,6 @@ TEST_NET4IN6[2]=10.2.1.254
# mcast address
MCAST6=ff02::1
-
-PEER_NS=bart
-PEER_CMD="ip netns exec ${PEER_NS}"
VRF=lisa
VRF_TABLE=1101
PBR_TABLE=101
@@ -176,8 +174,7 @@ setup()
set -e
# create namespace
- ip netns add ${PEER_NS}
- ip -netns ${PEER_NS} li set lo up
+ setup_ns PEER_NS
# add vrf table
ip li add ${VRF} type vrf table ${VRF_TABLE}
--
2.41.0
