On Fri, Aug 19, 2022 at 11:02 AM Tales Aparecida
<tales.aparecida@xxxxxxxxx> wrote:
>
> The "Getting Started" guide should be beginner-friendly, therefore
> add a note about the requirement of a clean source tree when running
> kunit_tool for the first time, and its related error.
>
> Signed-off-by: Tales Aparecida <tales.aparecida@xxxxxxxxx>
> ---
Hi Tales,
One suggestion on the note below. You could write the note as:
.. note ::
You may see the following error:
"The source tree is not clean, please run 'make ARCH=um mrproper'"
This happens because internally kunit.py specifies
``.kunit``(default option) as the
build directory in the command ``make O=output/dir``
through the argument ``--build_dir``. Hence, before starting
out-of-tree build,
the source tree must be clean.
There is also the same caveat mentioned in the "Build directory for
the kernel"
section of the :doc:`admin-guide </admin-guide/README>`, that is,
after its use, it must be used for all invocations of ``make``.
The good news is that it can indeed be solved by running
``make ARCH=um mrproper``, just be aware that this will delete the
current configuration and all generated files.
Regards,
Sadiya
> Documentation/dev-tools/kunit/start.rst | 16 ++++++++++++++++
> 1 file changed, 16 insertions(+)
>
> diff --git a/Documentation/dev-tools/kunit/start.rst b/Documentation/dev-tools/kunit/start.rst
> index 165d7964aa13..e4b73adde6d0 100644
> --- a/Documentation/dev-tools/kunit/start.rst
> +++ b/Documentation/dev-tools/kunit/start.rst
> @@ -19,6 +19,22 @@ can run kunit_tool:
>
> ./tools/testing/kunit/kunit.py run
>
> +.. note ::
> + You might see the error:
> + "The source tree is not clean, please run 'make ARCH=um mrproper'"
> +
> + That happens because internally kunit.py specifies the build directory in
> + the command ``make O=output/dir`` through the argument ``--build_dir``,
> + which is ``.kunit`` by default, and before starting out-of-tree build,
> + the source tree must be clean.
> +
> + There's also the same caveats mentioned in the "Build directory for the kernel"
> + section of the :doc:`admin-guide </admin-guide/README>`, that is,
> + after it's used it must be used for all invocations of ``make``.
> + The good news is that it can indeed be solved by running
> + ``make ARCH=um mrproper``, just be aware that this will delete the
> + current configuration and all generated files.
> +
> If everything worked correctly, you should see the following:
>
> .. code-block::
> --
> 2.37.1
>
