Hi, Kushwaha.
On 10/13/19 9:59 AM, Prabhakar Kushwaha wrote:
Hi All,
I am trying to understand test_gso test for IPv4 and IPv6 with
following piece of code
# listen on IPv*_DST, capture TCP into $TMPFILE
if [ "${PROTO}" == "IPv4" ] ; then
IP_DST=${IPv4_DST}
ip netns exec ${NS3} bash -c \
"nc -4 -l -s ${IPv4_DST} -p 9000 > ${TMPFILE} &"
elif [ "${PROTO}" == "IPv6" ] ; then
IP_DST=${IPv6_DST}
ip netns exec ${NS3} bash -c \
"nc -6 -l -s ${IPv6_DST} -p 9000 > ${TMPFILE} &"
RET=$?
else
echo " test_gso: unknown PROTO: ${PROTO}"
fi
I have couple of queries around it
a) why -l is being used for reading listen on IPv*_DST with -s option.
I was looking at https://www.computerhope.com/unix/nc.htm, following
has been mentioned:
-l : Used to specify that nc should listen for an incoming connection
rather than initiate a connection to a
remote host. It is an error to use this option in conjunction with the
-p, -s, or -z options.
Additionally, any timeouts specified with the -w option are ignored.
b) Even if there is requirement of -l option to use. can we provide
timeout option also. how? as -w dont work with -l.
I am facing an issue with Linux-5.3 Kselftest where even if
test_lwt_ip_encap.sh "exit", bpf/runner.sh is not
running next test case. It just wait until CRTL + c is pressed.
I meet same issue. "make run_tests -C bpf" bpf/runner.sh hang on
test_lwt_ip_encap.sh. And when i skip it,
test_tc_tunnel.sh also has this problem.
If I comment above code things work fine.
Please sugggest
--prabhakar (pk)
--
Best regards.
Liu Yiding
