On Thu, Apr 29, 2021 at 02:06:04PM +0300, Dan Carpenter wrote:
> This code was using IS_ERR() instead of PTR_ERR() so it prints 1 instead
> of the correct error code. Even better would be to use %pe which prints
> out the name of the error, as in "ENOMEM", "EINVAL" etc.
>
> Fixes: 25cb31768042 ("net/mlx5: E-Switch, Improve error messages in term table creation")
> Signed-off-by: Dan Carpenter <dan.carpenter@xxxxxxxxxx>
> ---
> v2: Use %pe instead of %ld.
>
> Leon says this goes through netdev instead of the RDMA tree.
Thanks,
Reviewed-by: Leon Romanovsky <leonro@xxxxxxxxxx>
