[PATCH][next] PCI: brcmstb: fix a missing if statement on a return error check

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Colin Ian King <colin.king@xxxxxxxxxxxxx>

The error return ret is not being check with an if statement and
currently the code always returns leaving the following code as
dead code. Fix this by adding in the missing if statement.

Addresses-Coverity: ("Structurally dead code")
Fixes: ad3d29c77e1e ("PCI: brcmstb: Add control of rescal reset")
Signed-off-by: Colin Ian King <colin.king@xxxxxxxxxxxxx>
---
 drivers/pci/controller/pcie-brcmstb.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index 7a3ff4632e7c..cb0c11b7308e 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -1154,6 +1154,7 @@ static int brcm_pcie_resume(struct device *dev)
 	clk_prepare_enable(pcie->clk);
 
 	ret = brcm_phy_start(pcie);
+	if (ret)
 		return ret;
 
 	/* Take bridge out of reset so we can access the SERDES reg */
-- 
2.27.0




[Index of Archives]     [Kernel Development]     [Kernel Announce]     [Kernel Newbies]     [Linux Networking Development]     [Share Photos]     [IDE]     [Security]     [Git]     [Netfilter]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Device Mapper]

  Powered by Linux