On Thursday 08 May 2008 04:33:53 Karsten Keil wrote: > On Wed, May 07, 2008 at 03:38:00PM -0700, Andrew Morton wrote: > > On Thu, 1 May 2008 16:16:52 -0400 > > > > Mark Asselstine <mark.asselstine@xxxxxxxxxxxxx> wrote: > > > >From looking at this driver the use of cli()/sti() within the do/while > > > > > > was a way to ensure interrupts were only disabled for short periods of > > > time while the bulk of the time interrupts were free to occur. The > > > use of the spin lock has eliminated the need to play with interrupts > > > in this way while still allowing for IO to be protected. > > > > OK. If we still want the interrupt-latency optimisation then we should > > switch over to using local_irq_disable(). But probably nobody cares. > > I had thought about using local_irq_disable() but it never progressed past a thought. > > > The remaining 3 sti() calls seem unneeded now that at no other point > > > in the driver is there a call to cli(). > > > > > > Signed-off-by: Mark Asselstine <mark.asselstine@xxxxxxxxxxxxx> > > > --- > > > drivers/isdn/hysdn/boardergo.c | 14 +++++--------- > > > > So... can we now do this? > > I think so. > I am in agreement here too. From my poking around this driver I see no reason why not. Regards, Mark > > --- a/drivers/isdn/hysdn/Kconfig~a > > +++ a/drivers/isdn/hysdn/Kconfig > > @@ -3,7 +3,7 @@ > > # > > config HYSDN > > tristate "Hypercope HYSDN cards (Champ, Ergo, Metro) support (module > > only)" - depends on m && PROC_FS && PCI && BROKEN_ON_SMP > > + depends on m && PROC_FS && PCI > > help > > Say Y here if you have one of Hypercope's active PCI ISDN cards > > Champ, Ergo and Metro. You will then get a module called hysdn. > > _ -- To unsubscribe from this list: send the line "unsubscribe kernel-janitors" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html