2018-06-22 20:42 GMT+09:00 Boris Brezillon <boris.brezillon@xxxxxxxxxxx>:
> Hi Masahiro,
>
> On Tue, 19 Jun 2018 13:28:11 +0200
> Boris Brezillon <boris.brezillon@xxxxxxxxxxx> wrote:
>
>> Hi Masahiro,
>>
>> On Fri, 15 Jun 2018 10:18:50 +0900
>> Masahiro Yamada <yamada.masahiro@xxxxxxxxxxxxx> wrote:
>>
>> > According to the Denali User's Guide, this IP needs three clocks:
>> >
>> > - clk: controller core clock
>> >
>> > - clk_x: bus interface clock
>> >
>> > - ecc_clk: clock at which ECC circuitry is run
>> >
>> > Currently, denali_dt.c requires a single anonymous clock and its
>> > frequency. However, the driver needs to get the frequency of "clk_x"
>> > not "clk". This is confusing because people tend to assume the
>> > anonymous clock means the core clock. In fact, I got a report of
>> > SOCFPGA breakage because the timing parameters are calculated based
>> > on a wrong frequency.
>> >
>> > Instead of the cheesy implementation, the clocks in the real hardware
>> > should be represented in the driver and the DT-binding.
>> >
>> > However, adding new clocks would break the existing platforms. For the
>> > backward compatibility, the driver still accepts a single clock just as
>> > before. If clk_x is missing, clk_x_rate is set to a hardcoded value.
>> > This is fine for existing DT of Socionext UniPhier, and also fixes the
>> > issue of Altera (Intel) SOCFPGA because both platforms use 200 MHz for
>> > the bus interface clock.
>> >
>> > Fixes: 1bb88666775e ("mtd: nand: denali: handle timing parameters by setup_data_interface()")
>>
>> Sorry for changing my mind, but I think this patch is doing more than
>> just fixing a bug. The bugfix should IMO be limited to unconditionally
>> setting ->clk_x_rate to 200000000 since this is what was done before
>> commit 1bb88666775e. And the remaining changes should go in nand/next.
>
> Do you want me to write this patch? Note that I can't really take this
> patch since Rob asked for a new version with DT bindings changes placed
> in a separate patch.
Sorry for the delay. I was traveling.
Now I am back home, and started to flush my TODO queue.
V4 will be soon.
--
Best Regards
Masahiro Yamada
--
To unsubscribe from this list: send the line "unsubscribe linux-kbuild" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
