TPM spec defines flow control over SPI. Client device can insert a wait
state on MISO when address is trasmitted by controller on MOSI. It can
work only on full duplex.
Half duplex controllers need to implement flow control in HW.
Add a flag for TPM to indicate flow control is expected in controller.
Signed-off-by: Krishna Yarlagadda <kyarlagadda@xxxxxxxxxx>
---
include/linux/spi/spi.h | 7 ++++---
1 file changed, 4 insertions(+), 3 deletions(-)
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h
index 988aabc31871..b88494e31239 100644
--- a/include/linux/spi/spi.h
+++ b/include/linux/spi/spi.h
@@ -184,8 +184,9 @@ struct spi_device {
u8 chip_select;
u8 bits_per_word;
bool rt;
-#define SPI_NO_TX BIT(31) /* No transmit wire */
-#define SPI_NO_RX BIT(30) /* No receive wire */
+#define SPI_NO_TX BIT(31) /* No transmit wire */
+#define SPI_NO_RX BIT(30) /* No receive wire */
+#define SPI_TPM_HW_FLOW BIT(29) /* TPM flow control */
/*
* All bits defined above should be covered by SPI_MODE_KERNEL_MASK.
* The SPI_MODE_KERNEL_MASK has the SPI_MODE_USER_MASK counterpart,
@@ -195,7 +196,7 @@ struct spi_device {
* These bits must not overlap. A static assert check should make sure of that.
* If adding extra bits, make sure to decrease the bit index below as well.
*/
-#define SPI_MODE_KERNEL_MASK (~(BIT(30) - 1))
+#define SPI_MODE_KERNEL_MASK (~(BIT(29) - 1))
u32 mode;
int irq;
void *controller_state;
--
2.17.1
