From: Lino Sanfilippo <l.sanfilippo@xxxxxxxxxx> After driver initialization tpm_tis_data->locality may only be modified in case of a LOCALITY CHANGE interrupt. In this case the interrupt handler iterates over all localities only to assign the active one to tpm_tis_data->locality. However this information is never used any more, so the assignment is not needed. Furthermore without the assignment tpm_tis_data->locality cannot change any more at driver runtime, and thus no protection against concurrent modification is required when the variable is read at other places. So remove this iteration entirely. Signed-off-by: Lino Sanfilippo <l.sanfilippo@xxxxxxxxxx> Acked-by: Jarkko Sakkinen <jarkko@xxxxxxxxxx> --- drivers/char/tpm/tpm_tis_core.c | 7 ++----- 1 file changed, 2 insertions(+), 5 deletions(-) diff --git a/drivers/char/tpm/tpm_tis_core.c b/drivers/char/tpm/tpm_tis_core.c index 65d1ec7eb4c3..d705dfb64cf9 100644 --- a/drivers/char/tpm/tpm_tis_core.c +++ b/drivers/char/tpm/tpm_tis_core.c @@ -728,7 +728,7 @@ static irqreturn_t tis_int_handler(int dummy, void *dev_id) struct tpm_chip *chip = dev_id; struct tpm_tis_data *priv = dev_get_drvdata(&chip->dev); u32 interrupt; - int i, rc; + int rc; rc = tpm_tis_read32(priv, TPM_INT_STATUS(priv->locality), &interrupt); if (rc < 0) @@ -740,10 +740,7 @@ static irqreturn_t tis_int_handler(int dummy, void *dev_id) set_bit(TPM_TIS_IRQ_TESTED, &priv->flags); if (interrupt & TPM_INTF_DATA_AVAIL_INT) wake_up_interruptible(&priv->read_queue); - if (interrupt & TPM_INTF_LOCALITY_CHANGE_INT) - for (i = 0; i < 5; i++) - if (check_locality(chip, i)) - break; + if (interrupt & (TPM_INTF_LOCALITY_CHANGE_INT | TPM_INTF_STS_VALID_INT | TPM_INTF_CMD_READY_INT)) -- 2.36.1
