On 10/14/19 11:02 AM, James Morse wrote:
Hi Prakhar,
(You've CC'd a few folk who work for 'arm.org'...)
On 11/10/2019 01:35, Prakhar Srivastava wrote:
Add support to carry ima measurement log
to the next kexec'ed session triggered via kexec_file_load.
I don't know much about 'ima', I'm assuming its the list of 'stuff' that has already been
fed into the TPM as part of SecureBoot. Please forgive the stupid questions,
The IMA logs are event logs for module load time signature
validation(based on policies) which are backed by the TPM. No SecureBoot
information is present in the log other than the boot aggregate.
Currently during kexec the kernel file signatures are/can be validated
prior to actual load, the information(PE/ima signature) is not carried
to the next session. This lead to loss of information.
Carrying forward the ima measurement log to the next kexec'ed session
allows a verifying party to get the entire runtime event log since the
last full reboot, since that is when PCRs were last reset.
Hmm, You're adding this as a linux-specific thing in the chosen node, which points at a
memreserve.
The question that normally needs answering when adding to the stuff we have to treat as
ABI over kexec is: how would this work from a bootloader that isn't kexec? Does it need to
work for non-linux OS?
This change is only intended to be executed in the path of
kexec_file_load and not intended to be executed by any boot loader.(Not
very aware of boot loader calls.). The logs are non intended to be
injected by the boot loader at all.
The change is configurable(CONFIG_IMA_KEXEC) under the IMA subsection
and can be disabled if not needed.
Changing anything other than the chosen node of the DT isn't something the kernel should
be doing. I suspect if you need reserved memory for this stuff, it should be carved out by
the bootloader, and like all other memreserves: should not be moved or deleted.
('fdt_delete_mem_rsv()' is a terrifying idea, we depend on the memreserve nodes to tell
use which 'memory' we shouldn't touch!)
fdt_delete_mem_rsv - is to cleanup any memory that's been mistakenly
still lying around in the same session while creating the fdt.
memblock_free is actually used to free up the reserved memory.
Thiago may have more insight, This is primarily a code that's been
ported from existing kernel for PowerPC.
https://github.com/torvalds/linux/blob/master/arch/powerpc/kernel/machine_kexec_file_64.c
Sharing with powerpc is a great starting point ... but, how does this work for ACPI systems?
How does this work if I keep kexecing between ACPI and DT?
I don't have an answer to this, just going through the call stack i dont
believe it depends on ACPI as such. I am not the expert here, but more
than willing to try out the scenario in question.(Can you point me to
some documentation to setup some environment to test this.)
Kexec_file_load call depends purely on DT implementation.
I'd prefer it we only had one way this works on arm64, so whatever we do has to cover both.
I can move the code to be only part of arm64 arch if absolutely
necessary. Thiago do you have any concerns on going back the path of
multiple code paths?
Does ima work without UEFI secure-boot?
Yes, IMA, the measurement is not dependent on any hardware capabilities.
TPM is needed to back the measurements but the IMA module will not fail
if TPM is not available.
In short Secure-boot has no impact on IMA.
If not, the Linux-specific UEFI 'memreserve' table might be a better fit, this would be
the same for both DT and ACPI systems. Given U-boot supports the UEFI API too, its
probably the right thing to do regardless of secure-boot.
It looks like x86 doesn't support this either yet. If we have to add something to support
ACPI, it would be good if it covers both firmware mechanisms for arm64, and works for x86
in the same way.
(How does this thing interact with EFI's existing efi_tpm_eventlog_init()?)
IMA does not interact with the TPM event log.
Only one of the PCR's is extended but not logged in the TPM logs. The
logging is done in IMA. The IMA measurement log in question is whats
needed to be carried over to via kexec_file_load call.
I am not sure if i addressed all your concerns, please let me know
if i missed anything. To me most concerns look to be towards the kexec
case and dependency on hardware(ACPI/TPM) during boot and early boot
services, where as carrying the logs is only during the kexec_file_load
sys call and does not interfere with that code path.
IMA documentation: https://sourceforge.net/p/linux-ima/wiki/Home/
Prakhar Srivastava
Thanks,
James
