Mark Brown, 2024-05-06T00:15:01+09:00:
> On Sat, May 04, 2024 at 09:37:06PM +0200, Karel Balej wrote:
>
> > +static const struct regulator_ops pm886_ldo_ops = {
> > + .list_voltage = regulator_list_voltage_table,
> > + .map_voltage = regulator_map_voltage_iterate,
> > + .set_voltage_sel = regulator_set_voltage_sel_regmap,
> > + .get_voltage_sel = regulator_get_voltage_sel_regmap,
> > + .enable = regulator_enable_regmap,
> > + .disable = regulator_disable_regmap,
> > + .is_enabled = regulator_is_enabled_regmap,
> > + .get_current_limit = pm886_regulator_get_ilim,
>
> Do these regulators actually enforce this limit or is this just a spec
> limit beyond which regulation may fail? If it's just a spec limit I'd
> not expect this operation to be provided, it's more for a hard limit
> where the regulator will detect and act on issues. I don't see an error
> interrupt or anything and this would be an unusual feature for a LDO.
I'm afraid I don't have the answer -- my only reference is the vendor
version of the driver and I don't see anything there based on which I
would be able to tell.
But based on what you write, my guess would be that it's just a spec limit.
Should I then drop this op and the max_uA values from all the
regulators?
Thank you,
K. B.
