Previously cp2112_gpio_irq_shutdown() always cancelled the
gpio_poll_worker, even if other IRQs were still active, and did not set
the gpio_poll flag to false. This resulted in any call to _shutdown()
resulting in interrupts no longer functioning on the chip until a
_remove() occurred (a.e. the cp2112 is unplugged or system rebooted).
Only cancel polling if all IRQs are disabled/masked, and correctly set
the gpio_poll flag, allowing polling to restart when an interrupt is
next enabled.
Signed-off-by: Danny Kaehn <danny.kaehn@xxxxxxxxxx>
---
Changes since v1 -- resolving comments from Andy:
- Addressed patch message missing parens
- Fixed opening bracket on newline
drivers/hid/hid-cp2112.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/hid/hid-cp2112.c b/drivers/hid/hid-cp2112.c
index 54c33a24f844..b24d398f430f 100644
--- a/drivers/hid/hid-cp2112.c
+++ b/drivers/hid/hid-cp2112.c
@@ -1168,7 +1168,11 @@ static void cp2112_gpio_irq_shutdown(struct irq_data *d)
struct cp2112_device *dev = gpiochip_get_data(gc);
cp2112_gpio_irq_mask(d);
- cancel_delayed_work_sync(&dev->gpio_poll_worker);
+
+ if (!dev->irq_mask) {
+ dev->gpio_poll = false;
+ cancel_delayed_work_sync(&dev->gpio_poll_worker);
+ }
}
static int cp2112_gpio_irq_type(struct irq_data *d, unsigned int type)
--
2.25.1
