On 30.04.2023 20:20, Luca Weiss wrote:
> The watch has a DRV2605 for haptics. Add a node for it based on the
> values found in the downstream board file.
>
> Signed-off-by: Luca Weiss <luca@xxxxxxxxx>
> ---
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Konrad
> arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts | 28 ++++++++++++++++++++++
> 1 file changed, 28 insertions(+)
>
> diff --git a/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts b/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts
> index d64096028ab1..eb73b992a696 100644
> --- a/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts
> +++ b/arch/arm/boot/dts/qcom-apq8026-huawei-sturgeon.dts
> @@ -7,6 +7,7 @@
>
> #include "qcom-msm8226.dtsi"
> #include "qcom-pm8226.dtsi"
> +#include <dt-bindings/input/ti-drv260x.h>
>
> /delete-node/ &adsp_region;
>
> @@ -68,6 +69,26 @@ &adsp {
> status = "okay";
> };
>
> +&blsp1_i2c2 {
> + clock-frequency = <384000>;
> +
> + status = "okay";
> +
> + vibrator@5a {
> + compatible = "ti,drv2605";
> + reg = <0x5a>;
> + enable-gpios = <&tlmm 60 GPIO_ACTIVE_HIGH>;
> +
> + mode = <DRV260X_ERM_MODE>;
> + library-sel = <DRV260X_ERM_LIB_D>;
> + vib-rated-mv = <2765>;
> + vib-overdrive-mv = <3525>;
> +
> + pinctrl-0 = <&vibrator_default_state>;
> + pinctrl-names = "default";
> + };
> +};
> +
> &blsp1_i2c5 {
> clock-frequency = <384000>;
>
> @@ -347,6 +368,13 @@ reset-pins {
> };
> };
>
> + vibrator_default_state: vibrator-default-state {
> + pins = "gpio59", "gpio60";
> + function = "gpio";
> + drive-strength = <2>;
> + bias-pull-down;
> + };
> +
> wlan_hostwake_default_state: wlan-hostwake-default-state {
> pins = "gpio66";
> function = "gpio";
>
